Hawking Technology 202-10248-01 manual Reset Button

GS108T Smart Switch Hardware Installation Guide

Table 2-1. Front Panel LEDs (continued)

	n/a	Off	No 10Mbps link is established on the
			port
10Mbps Link / ACT LED	Green	On - Solid	A valid 10Mbps link is established on
			the port
(Right LED)
	Green	On - Blinking	Packets transmission or reception is
			occurring on the port, linked at 10Mbps
			mode
	n/a	Off	No 1000Mbps link is established on the
			port
1000Mbps Link / ACT LED	Green	On - Solid	A valid 1000Mbps link is established on
			the port
(Both LEDs)
	Green	On - Blinking	Packets transmission or reception is
			occurring on the port, linked at
			1000Mbps mode

Reset Button

The Reset button of the GS108T triggers a hardware reset of the switch. Figure 2-3shows its location on the front panel. This action is equivalent to switching the unit power off and back on. The last saved configuration is loaded into the switch as it resets. To operate the reset button, insert a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs should extinguish and light again as the switch performs its Power On Self Test (POST).

Physical Description 2-3

v1.0, March 2007