Basic Setup

 

 

 

 

 

Channel setting (cont’d)

 

7) Press [K / L] to start scanning.

 

To skip a Preset channel

• The tuner will begin to search up or down

automatically. When a channel is found, the unit

You can set the unit to skip channels you can no longer

will stop searching and the picture will appear on

receive or seldom watch when you access channels

the TV screen.

using [PROG. / ].

• You can select a desired channel number using

 

[the Number buttons]. Refer to the following

1) Follow steps 1 to 3 in “Manual tuning” on page

Channel Plan table and press the three digits to

select the channel number.

29.

(To select channel 4, press [0] first and then press

 

[0]and [4]. Or press [4] and then “– – 4” appears 2) Select “Position” using [K / L], then press [B]. and wait for 2 seconds.)

• If this is the channel you want, press [s].

Channel Plan

Ch. Indication

TV Channel

01

- 10

IRA - IRJ, GAP

21

- 69

E21 - E69

74

- 78

X, Y, Z, Z+1, Z+2

80 - 99, 100

S1 - S20, GAP

121

- 141

S21 - S41

This unit can receive the Hyper and Oscar frequency bands.

3)Select the position number you wish to skip using [the Number buttons] or [K / L], then press [s].

4)Select “Skip” using [K / L], then press [B].

5)Select “ON” using [K / L], then press [s].

• To skip another channel, repeat steps 2 to 5.

6)Press [SETUP] to exit.

If you want to decode scrambled signals, select “Decoder” using [K / L], then press [B]. Select “ON” using [K / L], then press [s].

If “Skip” is set to “ON”, select “Skip” using [K / L], then press [B]. Select “OFF” using [K / L], then press [s].

To store another channel, repeat steps 4 to 7.

Move

You can replace two channels.

1) In stop mode, press [SETUP].

8) After completion, press [SETUP] to exit.

To select a channel

Notes on using [the Number buttons]:

Enter channel numbers as a two-digit number for the quickest result. For example, to select channel 6, press [0] and [6]. If you only press [6], channel 6 will be selected after 2 seconds. You can only select channels 1 to 99.

You can select the external input mode “AV1”, “AV2”, “AV3” or “AV4”.

To select “AV1”, press [0], [0], [1].

To select “AV2”, press [0], [0], [2].

To select “AV3”, press [0], [0], [3].

To select “AV4”, press [0], [0], [4].

2)Select “Channel” using [K / L], then press [ENTER].

3)Select “Move” using [K / L], then press [ENTER].

4)Select the position number you want to move the channel using [K / L], then press [ENTER].

You cannot select a position number where “– – –” appears next to the number, because “Skip” is set to “ON” for that position number.

5)Move the channel to another position number using [K / L], then press [ENTER].

• To move another channel, repeat steps 4 to 5.

6)Press [SETUP] to exit.

30 EN

Page 30
Image 30
Toshiba D-R160SB manual 30 EN, To skip a Preset channel, Move, To select a channel, Follow steps 1 to 3 in Manual tuning on