Toshiba D-R160SB If the timer programming did not complete correctly, Error numbers indicate

Checking, cancelling, or correcting the timer programming information

In the following example, No. 5 timer programming overlaps on No. 1 and No. 6 timer programmes. In such a case, you should correct the programme time to clear the overlap.

Timer Programming

Date Start End CH Mode PDC

1. 01/01 12:00 13:00 AV3 XP ON

2.---

3.	---			Overlap
4.	---		No.1 6
5.	01/01	12:30		14:00	P02	SP	OFF
6.	01/01	13:45		21:00	P12	SEP	OFF

7.---

8.---

1)Press [I/y ON/STANDBY] so that the icon disappears from the front panel display.

2)Press [TIMER PROG.].

Timer Programming list will appear.

3)Check the information on the list to be edited.

4)To clear the timer programming, select the desired programme using [K / L], then press [CLEAR].

To correct the timer programming

1)Select the desired programme using [K / L], then press [ENTER].

2)Correct the timer programming using [K / L / { / B].

3)Press [ENTER] again.

5)Press [TIMER PROG.] to exit.

6)Press [I/y ON/STANDBY] to return to the timer standby mode.

Note

•If a timer recording is proceeding, that programme is highlighted in red. In such a case, you cannot select any other programmes.

If the timer programming did not complete correctly

The error number appears on the Timer Programming list.

Timer Programming

		Date	Start	End	CH	Mode	PDC
	*	01/01	12:57	1:57	P08	E22	ON
2.		---
3.		---
4.		---
5.		---
6.		---
7.		---
8.		---

The error programme will be displayed in grey with an asterisk and have an error number.

The error numbers indicate:

E1–E22, E37–E39: Recording error

E23–E24: Unrecordable disc

E25: • Copy prohibited programme

•Cannot record because of the NTSC / PAL- 60 signal is received.

E26–E28: Copy prohibited programme

E29: Disc protected

E30: Disc full

E31: Already recorded 99 titles (Video mode)

E32: Already recorded 99 titles (VR mode)

E33: Already recorded 999 chapters

E34: No space for Control Information

E35: PCA (Power Calibration Area) full

E36: Already finalised Video format disc

E40: • There are some unrecorded parts due the overlapped timer programmes.

•Recording did not start at the start time. E41: Power failure

E42: No disc

The error programme will be deleted once you check the error in the programme list, or once you cancel the timer-standby mode and re-enter it.

Press [CLEAR] to erase the selected programme.

Introduction Connections Basic Setup Recording Playback

Editing Function Setup Others

EN 51