GarrettCom DX40 manual Ports and External Connectors

CHAPTER 1 - Overview

Specifications

1.3.6 Ports and External Connectors

The ports and external connectors of the DX40 are defined in Table 1-6.

Table 1-6. Ports and External Connectors

Port Name	Connector	Description
Ethernet, E1 and E2	LC	2 100FX multi/single mode small-format pluggables
	or	(SFP) port for fiber optic Ethernet-capable devices or
		Networks, or one 100FX SFP port and one 10/100
	LC + RJ45
		Mbps Ethernet port for connection to copper
		Ethernet-capable devices.
Serial, S1 and S2	DB9, female	Connection to serial async devices. Configurable to
		300, 600,1200, 2400, 4800, 9600, and 19.2, 28.8,
		33.6, 38.4, 57.6, 115.2, 230.4 Kbps.
Power Connection	Terminal block	Non-polarized power input.
Facility Ground Point	Screw	Facility ground connection point.

NOTE: All copper I/O connections must be made with shielded cables and connectors.

1.3.7 Indicators

The status indicators of the DX40 are described in Table 1-7. The operational status of the ports of the DX40 is indicated by a bank of LEDs on the beveled corner of the chassis, visible from the front and the side, as illustrated in Figure 1-3.

Table 1-7. Indicators

LED Name	Condition	Indication
S1 – S2	Green	Port is connected to an active serial device.
(Serial Ports)
	Off	Port is down.
	Flashing	Data is passing through the port.
E1 – E2	Green	Port is connected to an active Ethernet device.
(Ethernet Ports)
	Off	Port is down.
	Flashing	Data is passing through the port.
Power	Green	Normal functioning.
	Off	Power not connected.
	Yellow	Power on but diagnostics not yet run or
		diagnostics failed.
	Alternating Yellow	Diagnostics in progress.
	and Green
		DX40 Serial Device Router Installation Guide

6