GarrettCom DX40 manual Preparing for Installation, Tools, Site Suitability

Chapter 2

Installation

This chapter provides specific procedures for installing the Magnum DX40, preparing for installation, and uninstalling the device.

2.1Preparing for Installation

The DX40 is designed to be installed on a DIN rail system or on a panel.

2.1.1 Tools

Regardless of which mounting system you are using, the only tools you will need are screwdrivers: a small slotted screwdriver for the power connector and a medium slotted screwdriver for wall mounting and the grounding screw. (The 6-32 pan head grounding screw will accept both phillips head and slotted screwdrivers.)

The instructions in this manual cover only the physical installation. System configuration is handled through a web-based interface and is described in the Magnum Network Software – DX Administrator’s Guide.

2.1.2 Site Suitability

Be sure that your installation site meets the following criteria:

•

•

•

•

Conforms with the temperature and humidity ranges detailed in Table 1-2. Can meet the power requirements detailed in Table 1-5.

Will remain stable after the addition of the 3.5 lb. DX40.

Permits at least two inches of space between the DX40 and any other heat- producing device.

DX40 Serial Device Router Installation Guide

9