GarrettCom MAGNUM 6KM manual 3 P6KM4-4M12, 4 x PoE M12 Slot C, PoE LEDs Summary

Page 34

Magnum 6KM Mobile Ethernet Switch Installation and User Guide

07/10

5.1.3P6KM4-4M12, 4 x PoE M12 (Slot C)

The 6KM is available with the option of having PoE capabilities on the four M12 ports in slot C. This is used in conjunction with 6KMP-48VDC to add an additional four PoE ports to the existing four PoE ports in slot A.

The PoE (Power-over-Ethernet) M12 ports are similar to regular M12 ports, except they have the capability of providing power on each port to power up attached PD devices, per the IEEE802.3af PoE standard. The power-pass-through PoE ports are dependent upon the -48VDC input power to supply the PD power for these M12 (10/100) ports. Each port supplies up to 15watts to power attached PoE PD devices.

The LEDs on the PoE ports are slightly different compared to regular (non- PoE) M12 ports. When the PoE port is in use, the PoE LED is ON when connected properly to an IEEE 803.af compliant PD device on that port. When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data traffic is not affected by PoE.

PoE LEDs Summary

For PoE devices, each M12 PoE port supports only 802.3af complaint devices. The PoE LED is ON when the attached PD is drawing power from the port. The power is supplied on the data pairs, per IEEE802.3af PoE standard.

For non-PoE devices connected, the PoE port will act as a normal M12 port and the PoE LED is OFF. No power is sent out from the port.

The PoE ports in Magnum 6K’s with 48VDC power input act as a pass- through, so the 48VDC power input source to the Magnum 6KM must be strong enough to provide power to the 6K switch and to all 4-M12 ports with PD devices connected (up to 15 watts per PoE port).

In the case where the 48VDC power in not internally connected to the POE port pins and no power is coming to the PoE ports for some reason, all the PoE port LEDs are ON simultaneously to indicate a trouble condition. The ports will still operate properly for data traffic to non-PoE devices.

www . GarrettCom . com

29

Image 34
Contents Mobile Ethernet Switch GarrettCom, Inc Contacting GarrettCom, IncElectrical Safety requirements Canadian Emissions StatementSpecifications Troubleshooting Network Standards and Compliance, hardware SpecificationsTechnical Specifications Performance Maximum 10 Mbps Ethernet Segment LengthsFiber Multi-mode connector types supported Copper 10/100Mb connector types supportedCopper 1000Mb connector types supported Fiber Single-mode connector types supportedDual -Source DC Power Input Optional Power ConsumptionManagement Console connector Configuration Options see following pages Ordering InformationOptions and Extras Introduction Inspecting the Package and ProductProduct Description Magnum 6KM Mobile Ethernet Switch Packet Prioritization, 802.1p QOS Frame Buffering and Flow ControlWeb-browser, at ftp//ftp.garrettcom.com Managed Network Software for Magnum 6KM„ Managed switching for high performance Ethernet LANs Features and Benefits „ M12 Copper connections„ Fiber Ports Built-In „ MNS-6K-SECURE optional, for extra security Installation Connecting Twisted Pair for 10/100Mb CAT3, CAT5, UTP or STP Connecting Ethernet MediaMedia Ieee Standard Www . GarrettCom . com Connecting Fiber Optic Cable to LC ports Mounting Dimensions for 6KM with metal brackets DIN-Rail Mounting the Magnum 6KM00 x 9.58 inches 10.20 x 24.33 cm center-to-center Panel / Wall Mounting position Dual-Source DC power input Powering the Magnum DC 6KM Mobile Ethernet SwitchesSingle DC power input AC power input5a Alarm Contacts M12 6KM Console Port connector Connecting the Console Terminal to Magnum 6KM1 M12 Console Port pin assignments Filtering and Forwarding Switching FunctionalityOperation Address LearningAuto-CrossMDIX and Auto-negotiation, for M12 ports Flow-control, Ieee 802.3x standard Magnum 6KM Mobile Ethernet Switch Port Modules Power Budget Calculations for 6KM Modules with Fiber Media6KM Modules Blinking = Activity On = Link established LC 100Mb Fiber port, 2 LED per portLED Blinking = Activity LED6KM4-4M12, 4 x 10/100Mb M12 Slot C 3 P6KM4-4M12, 4 x PoE M12 Slot C PoE LEDs Summary6KM4-4MLC, 4 x Multimode LC Slot C 5 6KM4-4SLC, 6KM4-4SLCL, 4 x Singlemode LC Slot C7 6KM-2GMLC, 2 x Gigabit Multimode LC Slot B 6KM-2GM12, 2 x Gigabit M12 Slot B8 6KM-2GSLC, 6KM-2GSLCL, 2 x Gigabit Singlemode LC Slot B When Calling for Assistance TroubleshootingBefore Calling for Assistance Return Material Authorization RMA Procedure No Problem FoundAppendix a Warranty Information Shipping and Packaging InformationFig B1.0a Location of chassis ground Power Consumption B3.0 6KM DC Single Source Installation Standard 6KM male DC Power Input connectorB4.0 UL Requirements for DC-powered units B5.0 TroubleshootingAppendix C DC Dual Source Power Input C2.0 Magnum 6KM, with DC Dual-Source option C4.0 Features and Benefits of the DUAL-SOURCE DesignC5.0 6KM Dual Source Installation C3.0 DUAL-SOURCE OPTION, Theory of OperationC6.0 Ordering Information for Dual Source DC Power Standard 6KM Dual Source male DC Power Input connectorExample Magnum 6KM-48VDC Dual-Src-48V Standard 6KM male AC Power Input connector