GE ML1600, ML2400 quick start QS-17

Page 21

QUICK START GUIDE

ZSelect the Enter key.

The switch will ask if you would like to reboot the switch.

ZSelect Y for yes and Y again to save the new settings.

ZOnce the switch has completed a reboot, the new IP and subnet mask will be in effect.

Once the switch has rebooted you will need to log in again. To confirm that the IP address and subnet mask were saved correctly enter the command show setup followed by the Enter key. The Multilink switch will then provide an on-screen list of the switch settings including the switch IP address and subnet mask and if programmed, the default gateway. Once you have verified that the IP, subnet mask and default gateway settings are correct you can configure the switch via the web interface.

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE

QS–17

Image 21
Contents 1601-0220-A2 GE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-II QS-1 Fiber Twisted Pair copper cableStar Architecture QS.1.2 Supported Network TopologiesMesh Architecture Ring ArchitectureUnshielded Twisted Pair cable Ethernet Unshielded Twisted PairMetres max QS-5 RJ45 Connectors Metres max length QS.3.1 Fiber Optic Ethernet Wavelengths of light820nm 1300nm 1550nm QS.3.2 Single and Multi-mode cable Fiber Cable Cross Section and Physical SpecificationsSingle mode fiber Less attenuation per unit distance QS.4 Optical Power Budget Figure QS-4 Common Fiber Optic Connectors QS.4.1 Assigning an IP address to the Multilin SwitchQS-12 QS-13 QS-14 QS-15 QS-16 QS-17 QS.4.2 Assigning a static IP Address to a personnel computer QS-19 QS-20 Addresses now being used Select Run then enter CMD to start the DOS shellQS-22 QS-23 QS-24 Save Relay has switched over to the alternate port Background QS.5 Tagged VLAN’sConfiguring a Vlan within the switch QS.5.1 Configuring Tagged VLANsQS-29 QS-30 Save QS-32 QS-33 QS-34 QS-35 Configure QS-37 QS.5.2 Configuring the Multilink switch for Ring Only Mode QS-39 QS-40 Select the Edit icon From the configuration menu open the Rstp menuThen Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status QS-46 Disable LLA On Ports That are in a Ring You have completed the exercise QS.6.2 Selecting the Proper Version QS.6.1 Updating MultiLink FirmwareQS-50 Following procedure describes how to upgrade the firmware QS-52 ML1600/2400# show version QS.6.4 Updating Using the EnerVista Web Interface Software Using FTP Using Tftp QS-57 QS-58