GE ML2400 quick start ML1600/2400# show version

Page 57

QUICK START GUIDE

ML1600/2400# reboot

Proceed on rebooting the switch? [Y or N] Y

Rebooting now...

ZLogin to the switch and use the show version command to verify the version.

ML1600/2400# show version

ZIf necessary, upload the configuration file using the following commands.

If the current firmware is older than 1.7.3, use the loadconf command as shown below:

ZIf the current firmware is older than 1.7.3, enter the xmodem command as shown below:

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE

QS–53

Image 57
Contents 1601-0220-A2 GE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-II QS-1 Fiber Twisted Pair copper cableStar Architecture QS.1.2 Supported Network TopologiesMesh Architecture Ring ArchitectureUnshielded Twisted Pair cable Ethernet Unshielded Twisted PairMetres max QS-5 RJ45 Connectors Metres max length QS.3.1 Fiber Optic Ethernet Wavelengths of light820nm 1300nm 1550nm QS.3.2 Single and Multi-mode cable Fiber Cable Cross Section and Physical SpecificationsSingle mode fiber Less attenuation per unit distance QS.4 Optical Power Budget Figure QS-4 Common Fiber Optic Connectors QS.4.1 Assigning an IP address to the Multilin SwitchQS-12 QS-13 QS-14 QS-15 QS-16 QS-17 QS.4.2 Assigning a static IP Address to a personnel computer QS-19 QS-20 Addresses now being used Select Run then enter CMD to start the DOS shellQS-22 QS-23 QS-24 Save Relay has switched over to the alternate port Background QS.5 Tagged VLAN’sConfiguring a Vlan within the switch QS.5.1 Configuring Tagged VLANsQS-29 QS-30 Save QS-32 QS-33 QS-34 QS-35 Configure QS-37 QS.5.2 Configuring the Multilink switch for Ring Only Mode QS-39 QS-40 Select the Edit icon From the configuration menu open the Rstp menuThen Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status QS-46 Disable LLA On Ports That are in a Ring You have completed the exercise QS.6.2 Selecting the Proper Version QS.6.1 Updating MultiLink Firmware QS-50 Following procedure describes how to upgrade the firmware QS-52 ML1600/2400# show version QS.6.4 Updating Using the EnerVista Web Interface Software Using FTP Using Tftp QS-57 QS-58