GE ML2400, ML1600 quick start QS.6.4 Updating Using the EnerVista Web Interface Software

Page 58

QUICK START GUIDE

ZSelect the Transfer menu item and choose the Send File option.

ZEnter the location of the configuration file and select Xmodem for the protocol.

ZClick on the Send button.

The file will start to load as shown below:

ZOnce the transfer is complete, the switch will have to be rebooted either by entering Reboot or by switching the power off then on.

ML1600/2400# reboot

Proceed on rebooting the switch? [Y or N] Y

Rebooting now...

ZOnce the switch has rebooted, login and verify that the configuration was loaded correctly.

This completes the upgrade process.

QS.6.4 Updating Using the EnerVista Web Interface Software

Use the following steps to install the EnerVista Secure Web Management software.

ZDownload the latest MultiLink firmware from the GE Multilin web site to a convenient location on your hard drive.

QS–54

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE

Image 58

Contents 1601-0220-A2 GE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-II QS-1 Twisted Pair copper cable FiberMesh Architecture QS.1.2 Supported Network TopologiesStar Architecture Ring ArchitectureEthernet Unshielded Twisted Pair Unshielded Twisted Pair cableMetres max QS-5 RJ45 Connectors Metres max length Wavelengths of light QS.3.1 Fiber Optic Ethernet820nm 1300nm 1550nm Fiber Cable Cross Section and Physical Specifications QS.3.2 Single and Multi-mode cableSingle mode fiber Less attenuation per unit distance QS.4 Optical Power Budget QS.4.1 Assigning an IP address to the Multilin Switch Figure QS-4 Common Fiber Optic ConnectorsQS-12 QS-13 QS-14 QS-15 QS-16 QS-17 QS.4.2 Assigning a static IP Address to a personnel computer QS-19 QS-20 Select Run then enter CMD to start the DOS shell Addresses now being usedQS-22 QS-23 QS-24 Save Relay has switched over to the alternate port QS.5 Tagged VLAN’s BackgroundQS.5.1 Configuring Tagged VLANs Configuring a Vlan within the switchQS-29 QS-30 Save QS-32 QS-33 QS-34 QS-35 Configure QS-37 QS.5.2 Configuring the Multilink switch for Ring Only Mode QS-39 QS-40 From the configuration menu open the Rstp menu Select the Edit iconThen Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status QS-46 Disable LLA On Ports That are in a Ring You have completed the exercise QS.6.1 Updating MultiLink Firmware QS.6.2 Selecting the Proper VersionQS-50 Following procedure describes how to upgrade the firmware QS-52 ML1600/2400# show version QS.6.4 Updating Using the EnerVista Web Interface Software Using FTP Using Tftp QS-57 QS-58