GE ML1600, ML2400 quick start QS-39

Page 43

QUICK START GUIDE

ZDetermine which ports on each switch will be used to create the ring.

In this example it has been determined that the port named C5 will be one of the ports forming the ring.

ZClick on the port C5 to open the main port configuration screen.

From this screen we can see that the port named C5 is actually port 21.

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE

QS–39

Image 43
Contents 1601-0220-A2 GE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-II QS-1 Fiber Twisted Pair copper cableRing Architecture QS.1.2 Supported Network TopologiesStar Architecture Mesh ArchitectureEthernet Unshielded Twisted Pair Unshielded Twisted Pair cableMetres max QS-5 RJ45 Connectors Metres max length Wavelengths of light QS.3.1 Fiber Optic Ethernet820nm 1300nm 1550nm QS.3.2 Single and Multi-mode cable Fiber Cable Cross Section and Physical SpecificationsSingle mode fiber Less attenuation per unit distance QS.4 Optical Power Budget Figure QS-4 Common Fiber Optic Connectors QS.4.1 Assigning an IP address to the Multilin SwitchQS-12 QS-13 QS-14 QS-15 QS-16 QS-17 QS.4.2 Assigning a static IP Address to a personnel computer QS-19 QS-20 Addresses now being used Select Run then enter CMD to start the DOS shellQS-22 QS-23 QS-24 Save Relay has switched over to the alternate port Background QS.5 Tagged VLAN’sConfiguring a Vlan within the switch QS.5.1 Configuring Tagged VLANsQS-29 QS-30 Save QS-32 QS-33 QS-34 QS-35 Configure QS-37 QS.5.2 Configuring the Multilink switch for Ring Only Mode QS-39 QS-40 Select the Edit icon From the configuration menu open the Rstp menuThen Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status QS-46 Disable LLA On Ports That are in a Ring You have completed the exercise QS.6.2 Selecting the Proper Version QS.6.1 Updating MultiLink FirmwareQS-50 Following procedure describes how to upgrade the firmware QS-52 ML1600/2400# show version QS.6.4 Updating Using the EnerVista Web Interface Software Using FTP Using Tftp QS-57 QS-58