GE ML2400, ML1600 quick start QS-40

Page 44

QUICK START GUIDE

ZNote this port number.

Zfrom the Administration menu open the Set menu.

ZOpen the STP type setting.

ZSet STP to Rapid Spanning Tree (RSTP).

ZSave the setting.

QS–40

MULTILINK ML1600/2400 ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE

Image 44

Contents 1601-0220-A2 GE Multilin Incorporated. All rights reserved Table of Contents Table of Contents TOC-II QS-1 Twisted Pair copper cable FiberQS.1.2 Supported Network Topologies Star ArchitectureMesh Architecture Ring ArchitectureMetres max Unshielded Twisted Pair cableEthernet Unshielded Twisted Pair QS-5 RJ45 Connectors Metres max length 820nm 1300nm 1550nm QS.3.1 Fiber Optic EthernetWavelengths of light Fiber Cable Cross Section and Physical Specifications QS.3.2 Single and Multi-mode cableSingle mode fiber Less attenuation per unit distance QS.4 Optical Power Budget QS.4.1 Assigning an IP address to the Multilin Switch Figure QS-4 Common Fiber Optic ConnectorsQS-12 QS-13 QS-14 QS-15 QS-16 QS-17 QS.4.2 Assigning a static IP Address to a personnel computer QS-19 QS-20 Select Run then enter CMD to start the DOS shell Addresses now being usedQS-22 QS-23 QS-24 Save Relay has switched over to the alternate port QS.5 Tagged VLAN’s BackgroundQS.5.1 Configuring Tagged VLANs Configuring a Vlan within the switchQS-29 QS-30 Save QS-32 QS-33 QS-34 QS-35 Configure QS-37 QS.5.2 Configuring the Multilink switch for Ring Only Mode QS-39 QS-40 From the configuration menu open the Rstp menu Select the Edit iconThen Save Enable Status Once saved, select OK, then OK again to exit Select the Configuration Rstp RO Mode menu as shown above Then Save Enable status QS-46 Disable LLA On Ports That are in a Ring You have completed the exercise QS.6.1 Updating MultiLink Firmware QS.6.2 Selecting the Proper VersionQS-50 Following procedure describes how to upgrade the firmware QS-52 ML1600/2400# show version QS.6.4 Updating Using the EnerVista Web Interface Software Using FTP Using Tftp QS-57 QS-58