GarrettCom 6K25 manual Media Ieee Standard Connector

Page 31

Magnum 6K25 Managed Fiber Switch

Installation and User Guide (04/06)

Media

IEEE Standard

Connector

Twisted Pair (CAT 3, 4, 5)

10BASE-T

RJ-45

Twisted Pair (CAT 5)

100BASE-TX

RJ-45

NOTE : It is recommended that high quality CAT. 5 cables (which work for both 10 Mb and 100Mb) be used whenever possible in order to provide flexibility in a mixed-speed network, since dual-speed ports are auto-sensing for either 10 and 100Mb/s.

The following procedure describes how to connect a 10BASE-T or 100BASE- TX twisted pair segment to the RJ-45 port. The procedure is the same for both unshielded and shielded twisted pair cables.

1.Using standard twisted pair media, insert either end of the cable with an RJ-45 plug into the RJ-45 connector of the port. Note that, even though the connector is shielded, either unshielded or shielded cables and wiring may be used.

2.Connect the other end of the cable to the corresponding device

3.Use the LINK LED to ensure proper connectivity by noting that the LED will be illuminated when the unit is powered and proper connection is established

3.2.5Connecting Twisted Pair (CAT5E or better, Unshielded or Shielded) The RJ-45 Gigabit ports of the Magnum 6K25 can be connected to the media

types, 1000BASE-T or CAT 5E or better 100-ohm UTP or shielded twisted pair (STP) balanced cable. The CAT 5E or better 100-ohm UTP or shielded twisted pair (STP) balanced cable is recommended to use when making 1000BASE-TX connections. In either case, the maximum distance for unshielded twisted pair cabling is 100 meters (328 ft). See Section 4.3 for manual Up-Link switch on port 1 of copper port modules.

Media

IEEE Standard

Connector

Twisted Pair (CAT 5E)

1000BASE-T

RJ-45

NOTE : It is recommended that high quality CAT. 5E cables (which work for both 100 Mb and 1000Mb) be used whenever possible in order to provide flexibility in a mixed-speed network.

The following procedure describes how to connect a 1000BASE-T twisted pair segment to the RJ-45 port. The procedure is the same for both unshielded and shielded twisted pair cables.

1.1000Base-T connections require that all four pairs or wires be connected. Insert either end of the cable with an RJ-45 plug into the RJ-45 connector of the port. Note that, even though the connector is shielded, either unshielded or shielded cables and wiring may be used.

2.Connect the other end of the cable to the corresponding device

3.Use the LINK LED to ensure proper connectivity by noting that the LED will be illuminated when the unit is powered and proper connection is established

www. GarrettCom . com

24

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Managed Fiber Switch Trademarks Canadian Emission Contacting GarrettCom, IncIntroduction Table of ContentsRevisions TroubleshootingWww . GarrettCom . com Personal Hubs, 10Mb series Personal Switches , 10/100MbMedia Converters, 10Mb and 100Mb series Maximum 10 Mbps Ethernet Segment Lengths Technical SpecificationsPerformance Network Standards and Compliance, hardwareDC Power Supply Options Fiber Single-mode connector typesManagement Console connector Power Supply InternalAgency Approvals Alarm Contact OptionalNebs Testing and Certification Nebs certified Per-port MDI or Mdix on RJ-45Ordering Information 6K PoE Modules with 48VDC Pass-Through For Gigabit module configuration options6K PoE Modules with 48VDC Power Inside Introduction Inspecting the Package and Product Product Description Magnum 6K25 Managed Fiber Switch Magnum 6K25 and 6K25R chassis 1a Regular 6K25 front view, configured for 24 +1 Gb portsEight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Eight-Port Copper Module, 6K8-RJ45 The 6K25-Series’s8-port New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port ACT LK RX Gigabit 1000Mbps port modules Four-Port 10 Mb mm Fiber ST ModulesFrame Buffering and Flow Control Packet Prioritization, 802.1p QOS@ 1000Mb Fiber SC + 4@10/ 100Mb GarrettCom proprietary MIBs for Snmp Managed Network Software MNS-6K for Magnum 6K25-Series„ Features Fiber-Built-In „ Managed switching for high performance Ethernet LANs„ RJ-45 ports are MDI/MDIX supported „ Nebs and Etsi tested and certifiedApplications Example 1 Magnum 6K25 Switch for a Vlan applicationInternet Locating Magnum 6K25 Switches InstallationCopper Connecting Ethernet MediaConnecting Fiber Optic ST-type, twist-lock Ieee Standard Media Type Max. Distance Port Module FiberConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InMedia Ieee Standard Media Ieee Standard ConnectorRack-mounting for 19 Retma racks, regular Magnum 6K25s Table-Top or Shelf Mounting2 Reverse Magnum 6K25 units, rack-mounted in a frame Rack-mounting, Reverse version of the Magnum 6K25sPowering the Magnum Managed Fiber Switch Preparation for Installing and Removing 6KPMs 6K25 Port Module 6KPM InstallationRemove Chassis Cover 1a Removing Chassis Cover Installing 6KPM Cards in the Magnum 6K25 Uplink 2f Securely latching up 6KPM Cards into a Magnum 6K25 Firmly. .5.3a Top View 6 retaining s crews shown by arrows Removing 6KPM CardsConsole DB-9 Port Connecting the Console Terminal to Magnum 6K25 ManagementRemove 6KPM Card DB-9PinConsole1port connector Pin Signal Description1 RS-232 DB-9 Console Com port Serial port pin assignments Filtering and Forwarding Switching FunctionalityAddress Learning PWR Status LEDsUp-link MDI-MDIX on RJ-45 port modules, for port 1 only Auto-CrossMDIX and Auto-negotiation, for RJ-45 portsWww . GarrettCom . com Flow-control, Ieee 802.3x standard ’cvr 6KP46KPM Module Description Introduction Magnum 6K25 Managed Fiber Switch Port ModulesDual speed copper ports. Mode ST-type connectorsSegments. When installed in a Switch, the copper port6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module Transceivers all in one module. This Mode 100Mbps fiber opticMode SC-type connectors. It Provides an advantage Fiber functions in one Module of the 6K25 SwitchWww . GarrettCom . com Activity FULL/HALF Port@ 100Mbps Multi-Mode Fiber portLink Placing more ports on one module Magnum 6KP8-45MTModule is a combo module with Copper and fiber Small Form Factor6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port PoE LEDs Summary Fig. the top 8-RJ45 6KP8-45-2SLC 14 6KM-BLNK GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC ConnectorBefore Calling for Assistance Return Material Authorization RMA Procedure When Calling for AssistanceNo Problem Found Shipping and Packaging Information Appendix B Internal DC Power Supply OptionsB1.0 Specifications for Magnum 6K25 SWITCHES, DC Power Power Supply Internal -48VDC OptionB3.0 Applications for DC Powered Switches B4.1 UL Requirements for DC-powered units B4.0 InstallationMagnum 6K25s. see figure at right B5.0 Operation B7.0 TroubleshootingB6.0 Ordering Information GND Appendix C Internal DC Dual-Source Power OptionC5.0 Installation C4.0 Features and Benefits of the DUAL-SOURCE DesignExample Magnum 6K25R-24VDC or Magnum 6K25R-125VDC C5.1 UL RequirementsC6.0 Ordering Information Example Magnum 6K25R-48VDC
Related manuals
Manual 67 pages 19.91 Kb
Top Page Image Contents