GarrettCom 6K25 New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port, PoE LEDs Summary

Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)

and will allow both unshielded twisted pair (UTP) and shielded twisted pair (STP) cable connections. The 6KP8-RJ45 module is equipped with a Media Dependent Auto- Crossover (MDI-X) switch, which controls all ports for cascaded connection. This feature eliminates the need for a special twisted pair crossover cable when connecting to a hub or another switch.

Each port has an Activity (ACT) LED indicating packets being received, a Link (LK) LED that indicates proper connectivity with the remote device when lit, a FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off), and a “10/100” LED indicating 100Mb when lit (or 10 Mbps when off).

Important Note: The 10/100 RJ-45 ports are supported with Auto-negotiation and Auto-crossover (MDIX), which allow the RJ-45 ports to automatically Link with any RJ- 45 device and eliminate the use of cross-over cable.

5.2.10New PoE(Power Inside), model PI6KP8-45RJ (MDIX), 10/100Mb 8-port

The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have capability of providing power on each port to power up the PD devices, per the

6KP8-45RJ

IEEE802.3af PoE

standard. Only 4 x RJ-

8 Port@ 10/100Mb Copper ports

45 (10/100) ports

2

maxm. support

POE(Power Inside)

1

3

5

1

10/10

LK/AC

option in one 6K-unit.

POE

In this Fig. the top 4-

F/ H

2

4

6

10/10

LK/AC

RJ45 ports are

4

3

enhanced with POE

option whereas as

F/H

POE

1

LK/ACT

2

10/10

bottom 4- RJ-45 are

LINK

normal MDIX ports.

3

PoE

4

FULL/HALF

The 4-RJ45 POE

module are also

available with mix –n-

match with fiber modules. Please check the ordering information

Sec.1.2. for all the

various PI6K PoE modules option.

The LEDs on 6KP8-RJ45- PoE module are slightly different compared to regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the PoE LED is ON when connected properly to a 803.af compliant PD device on that port. When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data traffic is not affected by PoE.

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is marked as LINK/ACT, as shown in the diagram.

PoE LEDs Summary

•For PoE devices, each RJ-45 PoE port supports only 802.3af complaint www . GarrettCom . com

49