GarrettCom 6K25 manual 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module

Page 49

Magnum 6K25 Managed Fiber Switch

Installation and User Guide (04/06)

10/100 LED indicates the speed, if the LED is ON 100Mbps if it is OFF 10Mbps.

5.2.1a 6KP6-RJ10ST, 4@10/100Mbps RJ-45 and 2@10Mb multi-mode FX-ST “twist lock” Combo Module

The 6KP6-RJ10ST is a six port combo module that looks similar to the 100Mb combo module with the exception of 10Mb speed at the ST fiber module. The ST-connector functions as a fiber optic transceiver to support 10BASE-FX network segments. When installed in a Magnum 6K25 Managed Switch, the copper port supports the standard distance 100m on each port and the fiber port supports fiber optic cable distances up the IEEE-standard 10Mbps distance limits, i.e., typically 2km at full-duplex and half-duplex.

Each port has an Activity (ACT) LED indicating packets being received, a Link (LK) LED that indicates proper connectivity with the remote device when lit, and FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off). The 10/100 LED indicates the speed, if the LED is ON, 100Mbps if it is OFF, 10Mbps.

5.2.1b

6KP4-F10ST, 4@10Mb multi-mode FX-ST “twist lock” Module

The Magnum 6KP4-F10ST

 

 

 

6KP4-RJ10MST,

 

is a 10Mb multi-mode

 

4 Port@ 10Mb ST Fiber Port

 

fiber module with 4 ST-

 

 

 

2

 

 

 

Fiber ports. All four fiber

 

ACT

 

 

ACT

 

 

ports are ST connectors

 

 

 

 

 

 

F/H

 

 

F/H

 

1

and configured as 10Mb

3

1

TX

LK RX

5

TX

RX

ACT

 

 

ACT

 

 

 

 

 

 

 

 

 

Half-duplex by default.

 

F/H

TX

LK RX

F/H

LK

RX

The 10Mb ST-fiber ports

 

2

6 T

 

1

 

LINK

2

ACTIVITY

allow the user to connect

 

 

 

 

 

 

 

 

 

their legacy 10Mb network

 

3

FULL/HALF

 

 

to the Magnum 6K25

 

 

 

 

 

 

 

switch. They also provide a convenient way for the half duplex

 

 

hub to connect to the switch through 10Mb fiber ports. It supports distances according to the 10Base-FL standard i.e, 2Km distance for multi-mode fiber. (Single-mode for 10Km distance may be available as a special order).

Each port has an Activity (ACT) LED indicating packets being received, a Link (LK) LED indicating proper connectivity with the remote device when lit, and FDX/HDX LED indicating full-duplex mode when lit (or half-duplex if off).

www . GarrettCom . com

42

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Managed Fiber Switch Trademarks Canadian Emission Contacting GarrettCom, IncSpecifications Troubleshooting Revisions Magnum Line Performance Technical SpecificationsNetwork Standards and Compliance, hardware Maximum 10 Mbps Ethernet Segment LengthsFiber Single-mode connector types Fiber Multi-mode connector types supportedManagement Console connector Power Supply InternalNebs Testing and Certification Nebs certified Alarm Contact OptionalPer-port MDI or Mdix on RJ-45 Agency ApprovalsOrdering Information 6K PoE Modules with 48VDC Pass-Through For Gigabit module configuration options6K PoE Modules with 48VDC Power Inside Introduction Inspecting the Package and Product Product Description Magnum 6K25 Managed Fiber Switch Magnum 6K25 and 6K25R chassis 1a Regular 6K25 front view, configured for 24 +1 Gb portsEight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Eight-Port Copper Module, 6K8-RJ45 The 6K25-Series’s8-port New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port ACT LK RX Gigabit 1000Mbps port modules Four-Port 10 Mb mm Fiber ST ModulesFrame Buffering and Flow Control Packet Prioritization, 802.1p QOS@ 1000Mb Fiber SC + 4@10/ 100Mb GarrettCom proprietary MIBs for Snmp Managed Network Software MNS-6K for Magnum 6K25-Series„ Features Fiber-Built-In „ Managed switching for high performance Ethernet LANs„ RJ-45 ports are MDI/MDIX supported „ Nebs and Etsi tested and certifiedApplications Example 1 Magnum 6K25 Switch for a Vlan applicationWww . GarrettCom . com Locating Magnum 6K25 Switches InstallationConnecting Fiber Optic ST-type, twist-lock Connecting Ethernet MediaIeee Standard Media Type Max. Distance Port Module Fiber CopperConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InMedia Ieee Standard Table-Top or Shelf Mounting 1 Mountings for Magnum 6K25 units rack-mounted in a frame Rack-mounting for 19 Retma racks, regular Magnum 6K25sRack-mounting, Reverse version of the Magnum 6K25s Powering the Magnum Managed Fiber Switch2 Reverse Magnum 6K25 units, rack-mounted in a frame 6K25 Port Module 6KPM Installation Remove Chassis Cover Preparation for Installing and Removing 6KPMs1c Top View 6KPM retaining screws hold Face Plate Installing 6KPM Cards in the Magnum 6K25Uplink 2f Securely latching up 6KPM Cards into a Magnum 6K25 2g Top View 6KPM Module installed inside a 6K25 3b Removing a 6KPM Card Removing 6KPM CardsPin Signal Description Connecting the Console Terminal to Magnum 6K25 ManagementDB-9 Console port connector Console DB-9 PortFiltering and Forwarding Switching FunctionalityUp-link MDI-MDIX on RJ-45 port modules, for port 1 only Status LEDsAuto-CrossMDIX and Auto-negotiation, for RJ-45 ports Www . GarrettCom . com Flow-control, Ieee 802.3x standard ’cvr 6KP4ZXSC70 Introduction Magnum 6K25 Managed Fiber Switch Port Modules6KPM Module Description 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module @10Mb @100Mb Multi-mode FX-ST twist 1c 6KP4Lock Module Fiber functions in one Module of the 6K25 Switch Mode SC-type connectors. It Provides an advantageCopper ports and 2 Single Through combining copperDistances up the IEEE-standard Port@ 100Mbps Multi-Mode Fiber port100Mbps distance limits, i.e Module is a combo module with Magnum 6KP8-45MTCopper and fiber Small Form Factor Placing more ports on one module6KP8-MLC, 8 ports @ Connector Small100Mbps multi-mode LC Form Factor9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port PoE LEDs Summary Fig. the top 8-RJ45 GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector 14 6KM-BLNK Before Calling for Assistance When Calling for AssistanceNo Problem Found Return Material Authorization RMA ProcedureShipping and Packaging Information Appendix B Internal DC Power Supply Options Appendix a Warranty InformationB3.0 Applications for DC Powered Switches B4.0 B4.1 UL Requirements for DC-powered unitsB5.0 Operation Appendix C Internal DC Dual-Source Power OptionC4.0 Features and Benefits of the DUAL-SOURCE Design Example Magnum 6K25R-48VDC C5.1 UL RequirementsExample Magnum 6K25R-24VDC or Magnum 6K25R-125VDC
Related manuals
Manual 68 pages 23.74 Kb
Top Page Image Contents