GarrettCom 6K25 New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port, PoE LEDs Summary

Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)

5.2.10New PoE(Power Inside), model PI6KP8-45RJ (MDIX), 10/100Mb 8-port

The PoE RJ-45 ports act similar to regular RJ-45 ports, except they have capability of providing power on each port to power up the PD devices, per the

6KP8-45RJ

IEEE802.3af PoE

standard. Only 4 x RJ-

8 Port@ 10/100Mb Copper ports

45 (10/100) ports

2

maxm. support

POE(Power Inside)

1

3

5

1

10/10

LK/AC

option in one 6K-unit.

POE

In this Fig. the top 4-

F/ H

2

4

6

10/10

LK/AC

RJ45 ports are

4

3

enhanced with POE

option whereas as

F/H

POE

1

LK/ACT

2

10/10

bottom 4- RJ-45 are

LINK

normal MDIX ports.

3

PoE

4

FULL/HALF

The 4-RJ45 POE

module are also

available with mix –n-

match with fiber modules. Please check the ordering information

Sec.1.2. for all the

various PI6K PoE modules option.

The LEDs on 6KP8-RJ45- PoE module are slightly different compared to regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the PoE LED is ON when connected properly to a 803.af compliant PD device on that port. When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data traffic is not affected by PoE.

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is marked as LINK/ACT, as shown in the diagram.

PoE LEDs Summary

•For PoE devices, each RJ-45 PoE port supports only 802.3af complaint devices. The PoE LED is ON when the attached PD is drawing power from the port.

•For non-PoE devices connected, the PoE port will act as a normal RJ-45 port and the PoE LED is OFF. No power is being sent out from the port.

•The PoE ports in Magnum 6K’s with 48VDC power input act as a pass- through, so the 48VDC power source must be strong enough to provide power to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to 15 watts per PoE port).

•In the case where the 48VDC power in not internally connected and no power is coming to the PoE ports for some reason, all the PoE port LEDs are ON simultaneously to indicate a trouble condition. The ports will still operate properly for data traffic.

5.2.11New PoE(Power Pass-through), model P6KP8-RJ45 (MDIX), 10/100Mb 8-

port

www. GarrettCom . com

49