GE PB3-POS-RP user manual SW4 Settings, SW4 Switches 1,2

Page 26

26

PB3-POS-RP ProBridge

User Manual

SW4 Settings

SW4 – Switches 1,2, 4-6

These switches are reserved for Technical Support personnel. Do not use.

SW4 - Switch 3

Switch 3 on SW4 is used for signal termination for Port 0 on the PB3. Termination is important whenever multiple PB3 units are interconnected via the unit’s built-in RS485 network and the length between the PB3’s is more than 2000 feet. The default termination setting on the ProBridge 3 unit is with termination set to OFF. Whenever there are more than two PB3’s, termination on some of the PB3 units will change. The first PB3 and the last PB3 on the RS485 network will have termination set to ON (Down), all others between these two units will have their termination set to OFF (Up).

SW4 - Switches 7-8

Switches 7 and 8 on SW4 controls the Network protocol of Port 1 on the PB3. In other words, Port 1 on the PB3 can communicate as an RS232 or RS485 port depending on the needs on the Network environment.

SW4

Netwwork Protocol

7

8

RS232

D

U

RS485

U

D

Image 26
Contents PB3-POS-RP ProBridge Page Efore Y OU B Egin Ntroduction DIP Switch Settings GE Security Before You BeginCustomer Support Conventions Used in this ManualPB3-POS-RP ProBridge Introduction PB3-POS-RP OverviewDisclaimer CompatibilityAdditional Equipment DVMRe Type Software VersionPB3-POS-RP Box Contents PB3 System ComponentsInstallation Environment PB3-POS-RP ProBridge includesPower 4310-0008 220VAC Power Supply Power Supply Input Installation PB3 ComponentsTypical System Layout Monitor DVMRe TriplexRequired Dip Switch Information Default Factory Dipswitch SettingsDetailed Installation Steps Verify Operation PB3-POS-RP ProBridge SW1 -Switches Dip Switch SettingsSW1 Settings Display ModeAuto Line Feed Demo Mode Simulated MessageReset Clear Memory SW1 Switches SW2 Switches SW2 SettingsSW2 Switch Protocol Included Interfaces SW3 SettingsSW3 Switches SW3 SW4 Switch SW4 SettingsSW4 Switches 1,2 SW4 SwitchesSolution TroubleshootingProblem Probable Cause Equipment Required Hyperterminal SetupSetup Laptop connected to PB3 running HyperTerminal PB3-POS-RP ProBridge Enter Main Menu Option 2 Port #2 Menu Selection 3 Baud Rate Menu Selection 5 ModeMenu Selection 2 Protocol Options Menu Selection 4 ParityMenu Selection 6 Code Character Menus Selection 7 Device TypeMain Menu Option 3 Text Setup Compare Use this command to enable or disable Text filteringAppend Line Feed Bypass CountText String Example of setting Text Setup Menu options Receipt Main Menu Option 4 Alarm Setup Main Menu Option 4 BackupPB3 Specifications Cable Specifications ProBridge to Triplex DVMRe-CTProBridge to DVMRe DVMRe-CD/S DB9FRJ-45 Connector ProBridge to ProBridge CableProBridge to Printer Interconnect Cable ProBridge Interconnect Cable to serial device Part Number 4310-0068A Communication Type RS232Triport Cable Hardware Handshake Jumpers JP1 and JP2Triport Cable Modifications Contacting technical support Online publication library