Gefen EXT-DP-441 manual Installing the RMT-4IR Battery

Page 12

IR REMOTE CONTROL UNIT

Installing the RMT-4IR Battery

1.Remove the battery cover on the back of the IR Remote Control Unit.

2.Insert the included battery into the open battery slot. The positive (+) side of the battery should be facing up.

3.Replace the battery cover.

The Remote Control unit ships with two batteries. One battery is required for operation and the other battery is a spare.

Battery Slot

WARNING: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

9

Image 12

Contents Page Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Gefen 4x1 DisplayPort Switcher IntroductionGefen How It WorksOperation Notes Features FeaturesPackage Includes Front Panel Layout Front PanelInput Indicators 1 Front Panel DescriptionsBack Panel Layout Back PanelBack Panel Descriptions DP OutIR Remote Control Unit Layout and DescriptionInstalling the RMT-4IR Battery How to Resolve IR Code Conﬂicts Corresponding DIP Switch Settings for each IR ChannelConnecting the 4X1 Displayport Switcher How to Connect the 4x1 DisplayPort SwitcherWiring Diagram for the 4x1 DisplayPort Switcher Operating the 4X1 Displayport Switcher Front Panel Buttons and LED IndicatorsSwitching sources using the front panel buttons Switching sources using the IR Remote ControlSwitching sources using RS-232 Switching sources using TelnetSerial Port Settings RS-232 ControlRS-232 Commands Command Syntax#GETPASS Command #GETUSERNAME Command #IPCONFIG Command#RSTIP Command #SETHTTPPORT Command #SETPASS Command#SETTELNETPORT Command #SETUSERNAME Command #SGATEWAY Command#SIPADD Command #SNETMASK Command#USETELNETPASS Command #ACTIVEBOLO Command#FADEFAULT Function #IRRMTADD Command#LOCKPOWER Command #STBYMODE CommandRouting and Extender Commands Command DescriptionCommand Telnet Control Gefen#sipadd New IP set to Specifications Warranty Product RegistrationThis product uses UL listed power supplies