IR REMOTE CONTROL UNIT
How to Resolve IR Code Conflicts
In the event that IR commands from other remote controls interfere with the supplied IR Remote Control unit, changing the IR Remote Control’s IR channel will fix the problem. The IR Remote Control unit has a bank of DIP switches used for setting the IR channel. The DIP switch bank is located underneath the battery cover.
Left: Picture of the opened rear battery compartment of the IR remote showing the exposed DIP Switch bank between the battery chambers.
Corresponding DIP Switch Settings for each IR Channel
IR Channel 0 |
|
|
|
|
|
|
|
|
|
|
|
| ||||
(default) | IR Channel 1 | IR Channel 2 | IR Channel 3 | |||||||||||||
|
| ON |
|
| ON |
|
| ON |
|
| ON |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 |
| 1 | 2 |
| 1 | 2 |
| 1 | 2 |
| |||||
It is important that the IR channel on the Remote Control unit, matches the IR channel set on the 4x1 DisplayPort Switcher. For example, if both DIP switches on the IR Remote Control unit are set to IR channel 0 (both DIP switches down), then the 4x1 DisplayPort Switcher must also be set to IR channel 0. See page 21 on how to change the IR channel on the 4x1 DisplayPort Switcher.
10