ICP DAS USA MSM-508FCS, MSM-508FT user manual Serial Port, Mask:, MAC Address:, Modbus Net ID

Page 9

Industrial Ethernet Layer 2 Managed Switch – Web Management Manual

Mask

The (subnet) MASK is used to determine the subnet of an IP address. Same as the IP address, a MASK contains four bytes (32 bits) and it is often expressed in the dotted-decimal notation.

The factory default value is labeled beside the Switch case.

MAC Address

MAC Address is a hardware address. It’s a uniquely identifies the device of MAC layer network.

The standard (IEEE 802) format for human-readable is six groups of two hexadecimal digits, each digit separated by a dash or colon.

The factory default value is labeled on the Switch case.

Modbus Net ID

Specify the device ID for modbus protocol.

When the Network Setting is modified, you have to reboot the Switch to enable the new setting.

￿Serial Port

The Managed Switch supports two interfaces of serial communication. This function enables you to set up the transmission speed(baudrate),data bit(databit), parity check type (parity) and stop bit(stopbit).

April 29, 2008

6

Image 9
Contents Industrial Managed Ethernet Switch Contents Authentication Managed Switch Web Management Operation Step Web ConnectionApril 29 Information Basic SettingNetwork IP Address:Gateway: Mask: Serial PortMAC Address: Modbus Net IDDigital Input / Output Redundant Setting Redundant SettingRecovery Time Setting Recovery Time Cyber-Ring Protocol:Hello Time STP Protocol: Maxage Time STP Protocol: Forward Time STP Protocol:Mirror Port configurationEgress Egress & IngressPort Status TrunkingPort Cable CheckingSpeed DuplexRelay Output Relay AlarmAlarm Event setting Email AlarmReceiver Email SettingEmail Record 802.1Q Check Mode Vlan Mode802.1Q Secure Mode Port Based VlanPort based VLANs 802.1Q VLANsEgress Policy 2,1 Weight Fair queuing scheme QoS ModeQoS Strict priority schemeTag Priority Default PriorityIP ToS/DiffServ 802.1p Tag over Tos/DiffServDiagnosis AuthenticationPing AccountAccessible IP Reboot Setting Default SettingNetwork Setting Serial Port Setting