Foundry NetIron M2404C/M2404F Metro Access Switches
1.Copy the software image file to the appropriate TFTP directory on the workstation.
2.Log into the switch through the console port or through a Telnet session.
3.Download the software image from the TFTP server using the copy java command in Privileged (Enable) mode:
Example:
V3.3.9.img
NOTE The switch remains operational while the image is downloaded.
The Java image is downloaded into /Java directory.
4.Use the show version command to check the Java version on the switch.
Software Upgrade via Ethernet Port (Outband)
The switch has an Ethernet port which allows the user to access it for management purposes or software upgrades. This port, labeled ETH, is on the left side of the switch’s front panel and is not one of the switched ports. In order to configure this port for IP, the following commands must be used (from config mode):
This command will assign the IP address 10.1.1.7 and the netmask 255.0.0.0.
In order to see the current configuration of this IP interface, the following command should be used (from Privileged (Enable) mode):
In order to save the new Outband0 interface IP address, use the write command (from Privileged (Enable) mode).
January 2007 | © 2007 Foundry Networks, Inc. | 29 |