Fortinet 60c manual To change the Management IP Go to System Network Management

Using the web-based manager			Transparent mode installation
	Table 9: Transparent mode settings
	Administrator Password:
		IP:	_____._____._____._____
		Netmask:	_____._____._____._____
	Management IP	Default Gateway:	_____._____._____._____
		The management IP address and netmask must be valid for the network
		from which you will manage the FortiGate unit. Add a default gateway if the
		FortiGate unit must connect to a router to reach the management
		computer.
	DNS Settings	Primary DNS Server:	_____._____._____._____
		Secondary DNS Server:	_____._____._____._____

Using the web-based manager

You can use the web-based manager to complete the initial configuration of the FortiGate unit. You can continue to use the web-based manager for all FortiGate unit settings.

For information about connecting to the web-based manager, see “Connecting to the web-based manager” on page 16.

The first time you connect to the FortiGate unit, it is configured to run in NAT/Route mode.

To switch to Transparent mode using the web-based manager

1Go to System > Status.

2Select Change beside the Operation Mode.

3Select Transparent in the Operation Mode list.

4Select OK.

To reconnect to the web-based manager, change the IP address of the management computer to 10.10.10.2. Connect to the internal or DMZ interface and browse to https:// followed by the Transparent mode management IP address. The default FortiGate Transparent mode management IP address is 10.10.10.1.

To change the Management IP

1Go to System > Network > Management.

2Enter the management IP address and netmask that you recorded in Table 9 on page 40.

3Select access methods and logging for any interfaces as required.

4Select Apply.

40 01-28008-0018-20050128 Fortinet Inc.