Fortinet 60c manual Connecting to the command line interface CLI, To connect to the CLI

Getting started Connecting to the command line interface (CLI)

Connecting to the command line interface (CLI)

As an alternative to the web-based manager, you can install and configure the FortiGate unit using the CLI. Configuration changes made with the CLI are effective immediately without resetting the firewall or interrupting service.

To connect to the FortiGate CLI, you need:

•a computer with an available communications port,

•the null modem cable included in your FortiGate package,

•terminal emulation software such as HyperTerminal for Windows.

Note: The following procedure describes how to connect to the CLI using Windows

HyperTerminal software. You can use any terminal emulation program.

To connect to the CLI

1Connect the null modem cable to the communications port of your computer and to the FortiGate Console port.

2Make sure that the FortiGate unit is powered on.

3Start HyperTerminal, enter a name for the connection, and select OK.

4Configure HyperTerminal to connect directly to the communications port on your computer and select OK.

5Select the following port settings and select OK.

Bits per second	9600
Data bits	8
Parity	None
Stop bits	1
Flow control	None

6Press Enter to connect to the FortiGate CLI. The following prompt is displayed:

FortiGate-60 login:

7Type admin and press Enter twice. The following prompt is displayed:

Welcome !

Type ? to list available commands. For information about how to use the CLI, see the FortiGate CLI Reference Guide.

FortiGate-60 Installation Guide 01-28008-0018-20050128 17