Fortinet 60c manual Factory default protection profiles, Strict, Scan

Factory default FortiGate configuration settings			Getting started
	Table 5: Default firewall configuration
	Configuration setting	Name	Description
	Firewall policy	Internal ->Wan1	Source: All Destination: All
	Firewall address	All	Firewall address matches the source or
			destination address of any packet.
	Pre-defined service	More than 50	Select from any of the 50 pre-defined services
		predefined services	to control traffic through the FortiGate unit that
			uses that service.
	Recurring schedule	Always	The recurring schedule is valid at any time.
	Protection Profiles	Strict, Scan, Web,	Control how the FortiGate unit applies virus
		Unfiltered	scanning, web content filtering, spam filtering,
			and IPS.

The factory default firewall configuration is the same in NAT/Route and Transparent mode.

Factory default protection profiles

Use protection profiles to apply different protection settings for traffic that is controlled by firewall policies. You can use protection profiles to:

•Configure antivirus protection for HTTP, FTP, IMAP, POP3, and SMTP firewall policies

•Configure Web filtering for HTTP firewall policies

•Configure Web category filtering for HTTP firewall policies

•Configure spam filtering for IMAP, POP3, and SMTP firewall policies

•Enable the Intrusion Protection System (IPS) for all services

•Enable content logging for HTTP, FTP, IMAP, POP3, and SMTP firewall policies

Using protection profiles, you can build protection configurations that can be applied to different types of firewall policies. This allows you to customize types and levels of protection for different firewall policies.

For example, while traffic between internal and external addresses might need strict protection, traffic between trusted internal addresses might need moderate protection. You can configure firewall policies for different traffic services to use the same or different protection profiles.

Protection profiles can be added to NAT/Route mode and Transparent mode firewall policies.

The FortiGate unit comes preconfigured with four protection profiles.

Strict	To apply maximum protection to HTTP, FTP, IMAP, POP3, and SMTP traffic.
	You may not use the strict protection profile under normal circumstances but
	it is available if you have problems with viruses and require maximum
	screening.
Scan	To apply antivirus scanning and file quarantining to HTTP, FTP, IMAP,
	POP3, and SMTP content traffic.

22 01-28008-0018-20050128 Fortinet Inc.