Fortinet 5140-R manual Led

Page 9

FortiGate-5140 chassis

FortiGate-5140 shelf managers

The FortiGate-5140 shelf managers control chassis power up and power down, chassis power distribution, monitor chassis operating parameters, monitor and control chassis cooling, and can signal alarms if the chassis encounters problems. All FortiGate-5000 modules installed in the chassis communicate with the shelf managers.

The FortiGate-5140 shelf managers are factory installed. In most cases users do not have to install or configure the shelf managers.

Each shelf manager has two ethernet interfaces (ETH 0 and ETH 1). You can connect to ETH 0 from the shelf manager front panel. ETH 1 connects to the FortiGate-5140 backplane.

The shelf managers detect alarm conditions and communicate alarm signals to the FortiGate-5140 shelf alarm panel. The shelf alarm panel also contains serial interfaces for connecting to the shelf managers.

The shelf managers are hot swappable. You can remove a shelf manager by opening the extraction lever until the hot swap LED starts blinking. When the hot swap LED turns solid blue you can remove the shelf manager from the FortiGate-5140 chassis.

Figure 3: FortiGate-5140 shelf manager front panel

ETH 0 and 1 network

Reset

Hot Swap

activity LEDs

Button

LED

5000SM

ETH1

link/Act

ETH0

10/100

10/100

 

link/Act

Service

ETH0

RESET

STATUS

 

Hot Swap

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Retention

ETH0

Status

Handle

Screw

100base-T LEDs

 

 

 

 

Ethernet

 

 

Table 2: FortiGate-5140 shelf manager LEDs

 

 

 

 

 

 

LED

 

 

State

 

Description

 

 

 

 

 

ETH 0

10/100

Yellow

 

The Ethernet interface is connected at 100 Mbps.

ETH 1

 

 

 

 

link/Act

Green

 

Blinking LED indicates network traffic.

 

 

 

 

 

 

 

 

 

Off

 

No link.

 

 

 

 

 

 

STATUS

 

 

Green

 

This shelf manager is operating normally as the active shelf

 

 

 

 

 

manager. Usually the primary shelf manager operates as the

 

 

 

 

 

active shelf manager.

 

 

 

 

 

 

 

 

 

Red

 

This shelf manager is operating normally as the backup shelf

 

 

 

 

 

manager. Usually the secondary shelf manager operates as the

 

 

 

 

 

standby shelf manager.

 

 

 

 

HOT SWAP

Off

 

The shelf manager is not ready to be removed.

 

 

 

 

 

 

 

 

 

Blue

 

The shelf manager is ready to be removed.

 

 

 

 

 

 

 

 

 

Long blink

 

The shelf manager is starting up after being inserted into the

 

 

 

 

 

chassis.

 

 

 

 

 

 

 

 

 

Short blink

 

The shelf manager is shutting down in preparation for being

 

 

 

 

 

removed from the chassis.

 

 

 

 

 

 

FortiGate-5140-R Chassis Guide

 

01-30000-87705-20090108

9

http://docs.fortinet.com/ Feedback

 

Image 9
Contents FortiGate-5140-R FortiGate-5140-R Chassis Guide Contents Comments on Fortinet technical documentation For more informationFortiGate-5140 chassis Slot FortiGate-5140 chassis front panelSlot numbers FortiGate-5140 chassis back panelFortiGate-5140 shelf managers Physical description of the FortiGate-5140 chassisLED Shelf Manager fan and power control FortiGate-5140 shelf alarm panelSerial Shelf alarm panel telco alarmsConnecting to the shelf manager CLI using a serial port Shelf manager command line interface CLITo add or change the shelf manager root account password FortiGate-5140 Shelf Alarm PanelAir filter To use the shelf manager command line interface agent CliaCooling fan tray front panel Cooling fan traysCooling fan trays About data center DC power Power connection and configurationConnecting a FortiGate-5140 PEM to data center DC power Terminal strip Connectors48V/-60 VDC nom RTN positive To connect a FortiGate-5140 PEM to data center DC power Connecting the FortiGate-5140 chassis to data center groundTo connect the FortiGate-5140 chassis to data center ground ConnectorLED FortiGate-5053 power converter tray front and back panel48V Redundant FortiGate-5140 power supplies Basic power requirementsRedundant FortiGate-5053 power converter trays Redundant FortiGate-5053 power converter trays+ 1 redundancy 48V/-60 VDC RTN positive Terminal strip Connectors Wiring the FortiGate-5053 power converter tray Turning on FortiGate-5140 chassis powerTurning on FortiGate-5140 chassis power Mounting the FortiGate-5140 chassis Inserting 5000-series modules into a FortiGate-5140 chassisAir flow FortiGate-5140 hardware procedures Customer service and technical support Fortinet documentationRegister your Fortinet product Vcci