Extreme Networks 4700 manual Hardware Installation

Page 18

Hardware Installation

To mount the access point on a wall using the provided template:

1Photocopy the template (on the previous page) to a blank piece of paper. Do not reduce or enlarge the scale of the template.

CAUTION

If printing the mounting template (on the previous page) from an electronic PDF, dimensionally confirm the template by measuring each value for accuracy.

2Tape the template to the wall mounting surface.

If the installation requires the antenna be positioned vertically, the centerline reference (of the template) needs to be positioned vertically. The cabling shall exit the access point in a vertical direction.

If the installation requires the antenna be positioned horizontally, the vertical centerline (of the template) needs to be positioned horizontally. The cabling shall exit the access point in a horizontal direction.

3At mounting targets A and B, mark the mounting surface through the template at the target center.

4Discard the mounting template.

5At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and stop when there is 1mm between the screw head and the wall.

If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going directly into the wall and 6mm (0.23in.) if wall anchors are being used.

6If required, install and attach a security cable to the access point lock port.

7Attach the antennas to their correct connectors.

8For information on available antennas, see “Antenna Options” on page 14.

9Place the large center opening of each of the mount slots over the screw heads.

10Slide the access point down along the mounting surface to hang the mount slots on the screw heads.

CAUTION

Ensure you are placing the antennas on the correct connectors to ensure the successful operation of the access point.

18

Altitude 4700 Series Access Point Installation Guide

 

 

Image 18
Contents Altitude 4700 Series Access Point Installation Guide Page Table of Contents Registration Documentation Introduction Document ConventionsSite Preparation IntroductionAltitude 4700 Series Access Point Installation Guide Introduction Hardware Installation PrecautionsPackage Contents Hardware Installation Access Point Power Options Console Cable Reset Button Access Point PlacementAntenna Options Mounting the Access Point Wall Mounting Altitude 4700 Series Access Point Installation Guide Hardware Installation Altitude 4700 Series Access Point Installation Guide Suspended Ceiling T-Bar Installations Altitude 4700 Series Access Point Installation Guide Above the Ceiling Plenum Installations Altitude 4700 Series Access Point Installation Guide Hardware Installation Altitude 4700 Series Access Point Installation Guide LED Indicators Altitude 4700 Series Access Point Installation Guide Three Radio Altitude 4700 Series Access Point LEDs LED LED 2 LAN LED 3 WANDual Radio Altitude 4700 Series Access Point 2.4/5 Ghz LEDs Emerald YellowRear LED Basic 4700 Series Configuration Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Resetting the Access Point’s Password Configuring Basic Device Settings Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Radio Button Dual Radio SKU Three Radio SKU Altitude 4700 Series Access Point Installation Guide Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Basic 4700 Series Configuration Configuring Basic Security Basic 4700 Series Configuration Pass Key Testing Mobile Unit Connectivity Excluding MUs from AssociationWhere to Go From Here? Select Status and Statistics MU Stats from the menu treeBasic 4700 Series Configuration Specifications Altitude 4700 Series Access Point Physical CharacteristicsAltitude 4700 Series Access Point Electrical Characteristics Altitude 4700 Series Access Point Radio CharacteristicsAltitude 4700 Series Access Point Installation Guide Specifications Regulatory Compliance Country ApprovalsHealth and Safety Recommendations Safety in HospitalsPotentially Hazardous Atmospheres Wireless Devices Countries RF Exposure GuidelinesOperation in the US Radio Transmitters PartCE Marking and European Economic Area EEA Radio TransmittersClass B ITE Korea Warning Statement for Class B Other CountriesMexico Korea South Korea Waste Electrical and Electronic Equipment Weee Waste Electrical and Electronic Equipment Weee Customer Support Registration DocumentationPage