Extreme Networks manual Altitude 4700 Series Access Point Installation Guide

Page 21

power switch. The Power Injector receives power as soon as AC power is applied.

For standard 48 volt power adapter (5014000247R) and line cord installations:

aConnect RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and the access point’s GE1/POE port.

bVerify the power adapter is correctly rated according the country of operation.

cConnect the power supply line cord to the power adapter.

dAttach the power adapter cable into the power connector on the access point.

ePlug the power adapter into an outlet.

For PoE-enabled switch or controller installations:

aConnect an RJ-45 CAT5e (or CAT6) Ethernet cable between a PoE-enabled port and the access point’s GE1/POE port.

bEnsure the cable length from the PoE-enabled port to the access point does not exceed 100 meters (333 ft).

cVerify power is enabled on the PoE-enabled port.

CAUTION

Do not actually apply power to the AP until the cabling portion of the installation is complete.

6Verify the behavior of the access point LEDs. For more information, see “LED Indicators” on page 26.

7Align the bottom of the ceiling T-bar with the back of the access point.

8Orient the access point chassis by its length and the length of the ceiling T-bar.

9Rotate the access point chassis 45 degrees clockwise.

10Push the back of the access point chassis on to the bottom of the ceiling T-bar.

Altitude 4700 Series Access Point Installation Guide	21

Image 21

Contents Altitude 4700 Series Access Point Installation Guide Page Table of Contents Registration Documentation Document Conventions IntroductionIntroduction Site PreparationAltitude 4700 Series Access Point Installation Guide Introduction Hardware Installation PrecautionsPackage Contents Hardware Installation Access Point Power Options Console Cable Access Point Placement Reset ButtonAntenna Options Mounting the Access Point Wall Mounting Altitude 4700 Series Access Point Installation Guide Hardware Installation Altitude 4700 Series Access Point Installation Guide Suspended Ceiling T-Bar Installations Altitude 4700 Series Access Point Installation Guide Above the Ceiling Plenum Installations Altitude 4700 Series Access Point Installation Guide Hardware Installation Altitude 4700 Series Access Point Installation Guide LED Indicators Altitude 4700 Series Access Point Installation Guide LED LED 2 LAN LED 3 WAN Three Radio Altitude 4700 Series Access Point LEDsEmerald Yellow Dual Radio Altitude 4700 Series Access Point 2.4/5 Ghz LEDsRear LED Basic 4700 Series Configuration Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Resetting the Access Point’s Password Configuring Basic Device Settings Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Radio Button Dual Radio SKU Three Radio SKU Altitude 4700 Series Access Point Installation Guide Basic 4700 Series Configuration Altitude 4700 Series Access Point Installation Guide Basic 4700 Series Configuration Configuring Basic Security Basic 4700 Series Configuration Pass Key Excluding MUs from Association Testing Mobile Unit ConnectivitySelect Status and Statistics MU Stats from the menu tree Where to Go From Here?Basic 4700 Series Configuration Altitude 4700 Series Access Point Physical Characteristics SpecificationsAltitude 4700 Series Access Point Radio Characteristics Altitude 4700 Series Access Point Electrical CharacteristicsAltitude 4700 Series Access Point Installation Guide Specifications Country Approvals Regulatory ComplianceHealth and Safety Recommendations Safety in HospitalsPotentially Hazardous Atmospheres RF Exposure Guidelines Wireless Devices CountriesRadio Transmitters Part Operation in the USRadio Transmitters CE Marking and European Economic Area EEAClass B ITE Other Countries Korea Warning Statement for Class BMexico Korea South Korea Waste Electrical and Electronic Equipment Weee Waste Electrical and Electronic Equipment Weee Registration Documentation Customer SupportPage