Hardware Installation
4Mark a point on the finished side of the tile where the light pipe is to be located.
5Create a light pipe path hole in the target position on the ceiling tile.
6Use a drill to make a hole in the tile the approximate size of the access point LED light pipe.
CAUTION
Extreme Networks recommends care be taken not to damage the finished surface of the ceiling tile when creating the light pipe hole and installing the light pipe.
7Remove the light pipe’s rubber stopper (from the access point) before installing the light pipe.
8Connect the light pipe to the bottom of the access point. Align the tabs and rotate approximately 90 degrees. Do not over tighten.
9Fit the light pipe into hole in the tile from its unfinished side.
10Place the decal on the back of the badge and slide the badge onto the light pipe from the finished side of the tile.
11Attach the antennas to their correct connectors.
For information on the antennas available to the access point, see “Antenna Options” on page 14.
CAUTION
Ensure you are placing the antennas on the correct connectors to ensure the successful operation of the access point.
24 | Altitude 4700 Series Access Point Installation Guide |
|
|