Enterasys Networks FN 100 manual Port Status, Boot Prom, Firmware, Time, Date

The FN100 Chassis View

•Green indicates the FN100 is responding to device polls (valid connection).

•Magenta indicates that the FN100 is in a temporary stand-by mode while it responds to a physical change in the hub; note that port menus are inactive during this stand-by state.

•Blue indicates an unknown contact status – polling has not yet been established with the FN100.

•Red indicates the FN100 is not responding to device polls (device is off line, or device polling has failed across the network for some other reason).

UpTime

The amount of time, in a day(s) hh:mm:ss format, that the FN100 has been running since the last start-up.

Port Status

If management for your device supports a variable port display (detailed in The FN100 Port Status Displays, later in this chapter), this field will show the display currently in effect. If only a single port display is available — or if the default view is in effect — this field will state Default.

MAC

The physical layer address assigned to the interface associated with the IP Address used to define the device icon when it was added to NetSight Element Manager. MAC addresses are factory-set cannot be altered.

NOTE

Boot Prom, Firmware, Time, and Date, are not available for the FN100 at the time of this release.

Boot Prom

The revision of BOOT PROM installed in the FN100.

Firmware

The revision of device firmware stored in the FN100’s FLASH PROMs.

Time

The current time, in a 24-hour hh:mm:ss format, set in the FN100’s internal clock.

Date

The current date, in an mm/dd/yy format, set in the FN100’s internal clock.

Viewing Chassis Information 2-3