Enterasys Networks FN 100 manual Deleting a Workgroup

Workgroup Configuration

3.Choose the Type of workgroup being created or modified. This determines whether ports in this workgroup will forward only multicast packets, only unicast packets, or both multicast and unicast packets. The following are your possibilities:

•All — ports in this workgroup will forward both unicast and multicast packets.

•Multicast — ports in this workgroup will forward only multicast packets.

•Unicast — ports in this workgroup will forward only unicast packets.

4.If necessary, use the Refresh button to deselect any ports you have previously selected in the Port Selection area.

5.In the Ports In Workgroup area, click on the selection boxes corresponding to the ports you would like to include in this workgroup. Each port is identified by index number. Note that you cannot select the Network Management PPP port for inclusion into a workgroup.

6.Click on Add if you are adding a new workgroup, or on Apply if you are modifying an existing workgroup. New workgroup entries will be added to the Workgroup Table, and changes to existing workgroups will be reflected in the Workgroup Table.

7.Repeat steps 1-6 to add or modify any additional workgroups.

Deleting a Workgroup

In the Workgroup Table, highlight the work group you would like to delete. Click on Delete, the highlighted work group will be deleted. To have this change reflected in the Workgroup Table, click on Refresh. The currently defined workgroups will be displayed.

Configuring a Workgroup 5-3