Enterasys Networks MicroMMAC-T manual FC Errors, Soft Errors, Hard Errors Fields, Signals Lost

Page 73

Token Ring Statistics

A.C. Errors

The count detected by the management station of frames (Protocol Data Units or PDUs) containing errors in the A or C bits.

Abort Sequences

The management station’s count of abort sequences detected on the ring, which were issued by ring stations during transmission.

Internal Errors

The number of recoverable internal errors detected by the management station, indicating a ring station in marginal operating condition.

Lost Frames

The number of frames detected by the management station that were transmitted on the ring, but did not return to the transmitting station because the Timer Return to Repeat (TRR) timer expired.

Congestion Errors

The number of times the management station has not been able to copy a PDU addressed to it because of a lack of internal buffering.

FC Errors

The management station’s count of PDU detected on the ring with the A bits already set to 1, which indicates a possible electrical line disturbance, or a duplicate address on the ring.

Token Errors

The number of times the ring’s active monitor detected an error that required the transmission of a token.

Frequency Errors

The number of times that the management station has detected that the incoming frequency differs from the expected frequency by more than allowed.

Soft Errors

The total number of soft errors the management station has detected.

Hard Errors Fields

If a particular type of hard error is detected by the management station, “Detected” will be displayed in the appropriate hard error field. If no hard errors are detected, the field will display “None.”

Signals Lost

These errors occur if the management station has detected a loss of signal condition, which can be the result of a broken ring, a faulty wiring concentrator, or a receiver or transmitter malfunction.

Management Station Statistics

3-17

Image 73

Contents MicroMMAC-T Users Guide Page Virus Disclaimer Page Restricted Rights Notice Page Contents Chapter Token Ring Statistics ContentsChapter Station List and Station Map Chapter Token Ring AlarmsIndex Contents Viii Introduction Introduction Using This GuideRelated Manuals Using the MouseSoftware Conventions Left Mouse Button Right Mouse Button Common MicroMMAC-T Window Fields Using Window ButtonsIP Address Device NameLocation MAC AddressGetting Help Using On-line HelpGetting Help from Enterasys Global Call Center Introduction MicroMMAC-T Chassis View Viewing Chassis Information Front Panel Information Time Menu StructureDate Device Menu MicroMMAC-T Chassis View Menu StructurePort Status Menu Utilities Menu Network MenuModule Menus Help MenuPort Menus Ring Port Menus Port Status DisplaysSelecting a Port Status View Load ErrorsStatus Ring Port Status Port AssignmentPort Status Color Codes Viewing Hardware Types Chassis Manager WindowClick on MIBs Supported Device Type Managing the HubModule Type Accessing the TR Management Station Configuration Window Management Station ConfigurationStation Name Configuration Window Setting Station Name and LocationEnable Beacon Recovery Host Error Report Timer DelaySpecifying Ring Management Functions Inhibit Active MonitorEnable Ring Poll Recovery Selecting the Ring Viewing Network InformationNetwork Information Window Fields Viewing Module Status Ring of X Configured RingsToken Ring Board Status Window Fields Board NumberViewing Ring Port Status Accessing the Ring Port Status windowRing Port Status Window Fields Last Wire FaultPort Media TypeUsing the Media Type and Phantom Current Radio Buttons Setting the Device Date and Time13. Device Date Change Window Using an Uninterruptable Power Supply UPS14. The UPS Window Accessing the UPS WindowBattery Capacity Battery OutputUPS Uptime Line VoltageSetting the UPS ID Resetting the DeviceUsing the Test Option Using the Disconnect OptionEnabling and Disabling Port Mapping 15. The Port Map Window Enabling and Disabling Link TrapsEnabling and Disabling Link Traps at the Board Level Setting Token Ring Boards to AutomodeEnabling and Disabling Station Ports Enabling and Disabling PortsEnabling and Disabling Ring Ports Viewing I/F Summary Information Ring Out Enable/DisableType IndexDescription Physical StatusRaw Counts Interface Performance Statistics/Bar GraphsViewing Interface Detail RateUnicast AddressMaking Sense of Detail Statistics Transmitted Errors /Packets Transmitted Setting Total, Delta, or Cumulative Counts Statistics Window FeaturesToken Ring Statistics Viewing Elapsed, Average, and Peak Activity LevelsNew Timer Interval Text Box Setting the Statistics Poll IntervalNetwork Level Statistics Accessing the Network Statistics SelectionsNetwork Statistics Window General Information FieldsRing Status Fields Ring SpeedStations Inserted Active MonitorBeacon Statistics Soft Error FieldsInternal Errors Burst ErrorsAbort Sequences Token Errors Congestion ErrorsFrequency Errors Lost FramesTotal Errors Network Timer StatisticsNetwork Timer Statistics Window Fields Frames Network Performance GraphsKBytes Network Performance Graph Statistics Configuring the Network Performance GraphNetwork Events Red Traffic BlueTotal and Delta Graph Display Frame Size WindowFrame Sizes Window with Pie Chart Using the Pie and Bar Radio ButtonsProtocol Statistics Window Management Station Statistics Accessing the Management Station Statistics SelectionSoft Errors Fields Soft Errors FC ErrorsHard Errors Fields Signals LostLobe Wire Fault RecoveriesHard Errors Transmitted BeaconsPort Level Statistics Accessing the Station Port MenuStation Statistics Window Station Name Station Statistics Window General FieldsLink Time Station Statistics Window Performance FieldsStation Statistics Window Soft Error Fields Station Timer Statistics Window Port Performance Graphs Station Timer Statistics Window FieldsPort Performance Graph Statistics Total Errors RedConfiguring the Port Performance Graph Token Ring Statistics Ring-Level Alarm Limits Token Ring AlarmsRing-Level Alarm Limits for Network Events Accessing the Alarm Limits WindowToken Errors Ring-Level Station AlarmsLine Setting Ring-Level Alarm LimitsAccessing the Station Alarm Limits Window from the Port Menu Station-Level Alarm LimitsToken Ring Alarms Station Alarm Limits Window Setting Station-Level Alarm LimitsToken Ring Alarms Station List Window Station List and Station MapStation List Window Fields Address ModeGeneral Fields Number of Nodes/StationsStation Fields Viewing Station StatisticsSetting Station Alarms Viewing Station Timer StatisticsRemoving a Station from the Ring Viewing the Station Port Performance Graph Using the MAC/Canonical ButtonPrinting the Station List Station Map Resetting CountersNumber of Nodes Station Map Window FieldsStation Pop-up Text Boxes Viewing the Station MapNode Address Station Map with Text BoxesStation Command Menu Magnifying a Portion of the Map Manipulating the Station MapRotating the Station Map Resizing the Station Map Window Station List and Station Map Index SymbolsIndex-2 Index-3 Index-4