Enterasys Networks 6H308-48, 6H308-24 manual Distributed Chassis Management

Page 23

Distributed Chassis Management

1.12 DISTRIBUTED CHASSIS MANAGEMENT

Installation in the 6C107 MATRIX E7 Chassis

From a management perspective, 6x3xx modules in the MATRIX E7 chassis can be managed separately by individual IP addresses. Any modules in the MATRIX E7 can be selected and managed, however, no overall system wide settings are available.

NOTE: The MATRIX E7 chassis does not allow Distributed Chassis Management functionality as in the 6C105 chassis. Refer to the Enterasys Networks MATRIX E7 Overview and Setup Guide for more information.

Installation in the 6C105 SmartSwitch 6000 Chassis

The 6C105 SmartSwitch 6000 chassis can be viewed as a single entity with a single IP address. Its systems management functions are distributed to all modules, including the module. The chassis can be managed using a single IP address, or the modules can be managed separately by individual IP addresses. When the IP address of the chassis is used, system wide settings can be done from the chassis menu in Local Management, while module settings are done by selecting the specific module to be modified and changing the settings for that module.

1.13 MANAGEMENT

Management of the module can be either in-band or out-of-band. In-band remote management is possible through any SNMP compliant Network Management Software, such as Enterasys Networks’ Webview. Out-of-band Local Management is provided through the RJ45 COM port on the front panel using a VT100 terminal or a VT100 terminal emulator.

Local Management, described in a separate Enterasys Networks document, provides the ability to manage the module. Refer to the MATRIX E7 Series and SmartSwitch 6000 Series Modules Local Management User’s Guide for more information.

Introduction 1-7

Image 23
Contents 6H308-24 and 6H308-48 Fast Ethernet Installation Guide Page Page Vcci Notice FCC NoticeIndustry Canada Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction6H308-24 and 6H308-48 Modules HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION ConnectivityRuntime IP Address Discovery Broadcast Suppression Remote Monitoring RmonTraffic Rate Limiting PORT/VLAN Redirect FunctionsFlow Control Garp Switch OperationManagement Distributed Chassis ManagementStandards Compatibility Switching Options100BASE-FX Fiber Optic Network Network RequirementsPage Installation Unpacking the Module Installing Optional Flash UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing the Module into the 6C105 Chassis Connecting to the Network 6H308-246H308-48 Completing the Installation Page Using Lanview TroubleshootingCPU No link 4Troubleshooting OFF Troubleshooting ChecklistManagement User’s Guide for instructions Reset Button Using the Reset ButtonPage Module Specifications SpecificationsPhysical Fiber BudgetRegulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2
Related manuals
Manual 90 pages 12.31 Kb