Enterasys Networks 6H308-48, 6H308-24 manual Installation

Page 27

3

Installation

ELECTRICAL HAZARD: Only qualified personnel should install the 6H308-24 or 6H308-48.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions to install the 6H308-24 or 6H308-48. A Phillips screwdriver is required to install options into the module. Follow the order of the sections listed below to correctly install the module.

•Unpacking the module ( Section 3.1)

•Installing Optional FLASH Upgrade ( Section 3.2)

•Installing the module into the MATRIX E7 Chassis ( Section 3.3)

•Installing the module into the 6C105 Chassis ( Section 3.4)

•Connecting to the Network ( Section 3.5)

•Completing the Installation ( Section 3.6)

Installation 3-1

Image 27

Contents 6H308-24 and 6H308-48 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction6H308-24 and 6H308-48 Modules Connectivity Runtime IP Address DiscoveryHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Broadcast Suppression Remote Monitoring RmonTraffic Rate Limiting PORT/VLAN Redirect FunctionsFlow Control Garp Switch OperationManagement Distributed Chassis ManagementStandards Compatibility Switching Options100BASE-FX Fiber Optic Network Network RequirementsPage Installation Unpacking the Module Installing Optional Flash UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing the Module into the 6C105 Chassis Connecting to the Network 6H308-246H308-48 Completing the Installation Page Using Lanview TroubleshootingCPU No link 4Troubleshooting OFF Troubleshooting ChecklistManagement User’s Guide for instructions Reset Button Using the Reset ButtonPage Module Specifications SpecificationsPhysical Fiber BudgetRegulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2

Related manuals

Manual 90 pages 12.31 Kb