Enterasys Networks 6H308-48, 6H308-24 manual

Page 3

ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures.

NOTICE

Enterasys Networks and its licensors reserve the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS AND ITS LICENSORS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF ENTERASYS NETWORKS AND ITS LICENSORS HAVE BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

35 Industrial Way

Rochester, NH 03866-5005

Enterasys Networks, Inc. is a subsidiary of Cabletron Systems, Inc.

©2000 by Enterasys Networks, Inc. All Rights Reserved

Printed in the United States of America

Order Number: 9033549 December 2000

LANVIEW is a registered trademark of Enterasys Networks or its licensors; SmartSwitch and Enterasys Networks are trademarks of Enterasys Networks or its licensors. SPECTRUM is a registered trademark of Aprisma Management Technologies or its licensors.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Image 3
Contents 6H308-24 and 6H308-48 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpIntroduction Introduction6H308-24 and 6H308-48 Modules Connectivity Runtime IP Address DiscoveryHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION Broadcast Suppression Remote Monitoring RmonTraffic Rate Limiting PORT/VLAN Redirect FunctionsFlow Control Garp Switch OperationManagement Distributed Chassis ManagementStandards Compatibility Switching Options100BASE-FX Fiber Optic Network Network RequirementsPage Installation Unpacking the Module Installing Optional Flash UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing the Module into the 6C105 Chassis Connecting to the Network 6H308-246H308-48 Completing the Installation Page Using Lanview TroubleshootingCPU No link 4Troubleshooting OFF Troubleshooting ChecklistManagement User’s Guide for instructions Reset Button Using the Reset ButtonPage Module Specifications SpecificationsPhysical Fiber BudgetRegulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2
Related manuals
Manual 90 pages 12.31 Kb