Enterasys Networks VH-8G manual Displays/configures extended bridge capabilities provided by

Page 16

Selection

Description

Device Control Menu

 

Port Configuration

Enables any port, enables/disables flow control, and sets

 

communication mode to auto-negotiation, full duplex or half

 

duplex.

Port Information

Displays operational status, including link state, flow control

 

method, and duplex mode.

Spanning Tree

Enables Spanning Tree Algorithm; also sets parameters for

Configuration

hello time, maximum message age, switch priority, and

 

forward delay; as well as port priority and path cost.

Spanning Tree

Displays full listing of parameters for the Spanning Tree

Information

Algorithm.

Mirror Port

Sets the source and target ports for mirroring.

Configuration

 

Port Trunking

Specifies ports to group into aggregate trunks.

Configuration

 

BStorm Control

Allows you to enable broadcast storm control and set the

Configuration

packet-per-second threshold.

IGMP Configuration

Configures IGMP multicast filtering.

Extented Bridge

Displays/configures extended bridge capabilities provided by

Configuration

this switch, including support for traffic classes, GMRP

 

multicast filtering, and VLAN extensions.

802.1P Configuration

Configures default port priorities and queue assignments.

802.1Q VLAN

Displays basic VLAN information, such as VLAN version

Base Information

number and maximum VLANs supported.

802.1Q VLAN Current

Displays VLAN groups and port members.

Table Information

 

802.1Q VLAN Static

Configures VLAN groups via static assignments, including

Table Configuration

setting port members, or restricting ports from being

 

dynamically added to a port by the GVRP protocol.

Port Assignment

Displays/configures port-specific VLAN settings, including

VLAN Configuration

PVID, ingress filtering, and 802.1Q trunks.

Multicast Router Port

Displays the ports on the switch attached to a neighboring

Information

multicast router/switch for each VLAN ID.

Static Multicast Router

Assigns ports that are attached to a neighboring multicast

Port Cfg

router/switch.

IGMP Member Port

Assigns ports that are attached to hosts who want to receive

Configuration

a specific multicast service.

Port Security

Allows you to enable and configure port security for the

Configuration

switch.

Network Monitor Menu

 

Port Statistics

Displays statistics on network traffic passing through the

 

selected port.

RMON Statistics

Displays detailed statistical information for the selected port

 

such as packet type and frame size counters.

Unicast Address Table

Provides full address listing, as well as search and clear

 

functions.

 

 

8 VH-8G User Interface

VH-8G

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Vertical Horizon VH-8G Gigabit Ethernet Switch Management GuidePage 9033640 9033640 Table of Contents Snmp Management Appendix A. Spanning Tree ConceptsAppendix B. Virtual Lans Vlans Vi Table of Contents Configuration Options Management OverviewRequired Connections Console Port Out-of-Band ConnectionsTelnet Connection In-Band ConnectionsIn-Band Network Connection VH-8G User Interface OverviewUser Access Factory Defaults Factory Default SettingsGvrp Main Menu Selection DescriptionDisplays/configures extended bridge capabilities provided by System Information Menu System Information MenuDisplaying System Information System InformationDisplaying Switch Version Parameter DescriptionManagement Setup Menu Management Setup MenuChanging the Network Configuration Network ConfigurationIP Configuration IP ConfigurationIP Connectivity Test Ping IP Connectivity TestHttp Configuration 10. Http ConfigurationConfiguring the Serial Port 11. Serial Port Configuration12. Snmp Configuration Assigning Snmp ParametersConfiguring Community Names 13. Snmp CommunitiesConfiguring IP Trap Managers 14. IP Trap ManagersConsole Login Configuration 15. Console Login ConfigurationUsing Tftp Protocol to Download Over the Network Downloading System SoftwareSaving the System Configuration 17. Configuration Save & RestoreConfiguring Management Access 18. Management ConfigurationConfiguring the Switch 19. Device Control MenuNot implemented in the current firmware release Configuring Port Parameters 20. Port ConfigurationViewing the Current Port Configuration 21. Port InformationUsing the Spanning Tree Algorithm 22. Spanning Tree Configuration Configuring Bridge STADevice with the lowest MAC address will then Configuring STA for Ports 24. Spanning Tree Port ConfigurationViewing the Current Spanning Tree Configuration 25. Spanning Tree InformationDisplaying the Current Bridge STA 26. Bridge STA InformationDisplaying the Current STA for Ports 27. Spanning Tree Port InformationRules defining port status are Using a Mirror Port for Analysis 28. Mirror Port ConfigurationConfiguring Port Trunks 29. Port Trunking Configuration Igmp Multicast Filtering Configuring Igmp 30. Igmp ConfigurationConfiguring Broadcast Storm Control 31. Broadcast Storm Control ConfigurationConfiguring Bridge MIB Extensions 32. Extended Bridge ConfigurationBy setting this parameter to False Configuring Traffic Classes 33 .1P ConfigurationPort Priority Configuration 34 .1P Port Priority Configuration802.1P Port Traffic Class Information 35 .1P Port Traffic Class InformationConfiguring Virtual LANs 802.1Q Vlan Base Information802.1Q Vlan Current Table Information 37 .1Q Vlan Current Table Information802.1Q Vlan Static Table Configuration 38 .1Q Vlan Static Table Configuration39 .1Q Vlan Static Table Configuration Example Port Assignment Vlan Configuration 40. Port Assignment Vlan ConfigurationMulticast Router Port Information 41. Multicast Router Port InformationStatic Multicast Router Port Configuration 42. Static Multicast Router Port ConfigurationIgmp Member Port Configuration 43. Igmp Member Port ConfigurationPort Security Configuration 44. Port Security ConfigurationMonitoring the Switch 45. Network Monitor MenuDisplaying Port Statistics 46. Port StatisticsDisplaying Rmon Statistics 47. Rmon StatisticsDrop Events Displaying the Unicast Address Table 48. Unicast Address TableDisplaying the IP Multicast Registration Table 49. IP Multicast Registration TableConfiguring Static Unicast Addresses 50. Static Unicast Addreeess Table ConfigurationResetting the System Logging Off the System64 VH-8G User Interface Configuring & Monitoring the Switch Common TasksSetting Password Protection Connecting via Telnet Checking Network Configuration StatusAssigning an IP Address Setting Snmp Management Access Viewing Switch StatisticsConfiguring Port Mirroring Downloading a Software UpgradeDownloading Via the Serial Port SuccessDownloading Via Tftp Configuring Spanning Tree Parameters Configuring VLANs Configuring Class of ServiceConfiguring Port Operation Configuring the Unicast Address Table Setting a Default Gateway Configuring BootPConfiguring Port Trunks VH-8G Snmp Management Snmp ProtocolMIB Objects RFC 1213 MIB-IIRFC 1643 Ethernet-Like MIB RFC 1573 Interfaces Evolution MIBRFC 1493 Bridge MIB Ieee 802.1Q Q-MIB Compiling MIB Extensions Enterasys WebsiteEnterasys Proprietary MIB Extensions Appendix A. Spanning Tree Concepts Spanning Tree FeaturesGeneral Figure A-1. Spanning Tree Using an VH-8G Switch Spanning Tree Protocol in a NetworkTable A-1. Spanning Tree Protocol Defaults Spanning Tree Protocol ParametersSpanning Tree Protocol Operation 9033640 Spanning Tree Concepts VH-8G Appendix B. Virtual Lans Vlans VLANs and Frame TaggingVH-8G Vlan Configuration Assigning Ports to VLANsVlan Classification Port OverlappingForwarding Tagged/Untagged Frames Automatic Vlan RegistrationForwarding Traffic with Unknown Vlan Tags Appendix C. Class of Service Incoming tagged frames contain a priority level rangeFigure C-1. Class of Service Example Appendix D. IP Multicast Filtering Igmp Snooping and IP Multicast FilteringVH-8G Index Tftp 9033640 Index Page Page 150183-102 R01
Top Page Image Contents