Enterasys Networks VH-8G manual Configuring Static Unicast Addresses

Page 70

Configuring Static Unicast Addresses

Use the Static Unicast Address Table Configuration screen to manually configure host MAC addresses in the unicast table. You can use this screen to associate a MAC address with a specific VLAN ID and switch port as shown below.

 

 

Vertical Horizon Local Management -- VH-8G

 

 

 

Static Unicast Address Table Configuration

 

 

VID

MAC Address

Port

Status

 

 

 

------------------------------------------------------------------------

 

 

1

00-00-00-E8-43-12

1

Permanent

 

 

Sorted by : VID + MAC

VID

: 1

MAC: 00-00-00-00-00-00

 

 

VID

: 1

Port

: 1

 

 

 

MAC : 00-00-00-00-00-00 Status : Permanent

 

 

[Show]

[More]

 

[Set]

 

 

 

 

 

<OK>

 

 

 

 

 

Use <TAB> or arrow keys to move. <Enter> to select

 

 

 

 

 

Figure 2-50. Static Unicast Addreeess Table Configuration

 

 

 

 

 

 

Parameter

Description

 

 

 

 

VID

The VLAN group this port is assigned to.

MAC Address

The MAC address of a host device attached to this switch.

Port

The port the host device is attached to.

Status

The status for an entry can be set to:

 

 

Permanent:

This entry is currently in use and will remain

 

 

 

so after the next reset of the switch.

 

 

DeleteOnReset:

This entry is currently in use and will remain

 

 

 

so until the next reset.

 

 

Invalid:

Removes the corresponding entry.

 

 

DeleteOnTimeOut: This entry is currently in use and will remain

 

 

 

so until it is aged out. (Refer to Address Table

 

 

 

Aging Time on page 60.)

 

 

Other:

This entry is currently in use but the

 

 

 

conditions under which it will remain so differ

 

 

 

from the preceding values.

[Show]

Displays the static address table sorted on VID as the primary key

 

 

and MAC address as secondary key.

[More]

Scrolls through entries in the static address table.

[Set]

Adds the specified entry to the static address table, such as

 

 

shown in the following example:

 

 

VID : 1

MAC : 00-00-00-e8-34-22

 

 

Port : 1

 

 

 

 

Status : Permanent

62 VH-8G User Interface

VH-8G

Image 70
Contents Vertical Horizon VH-8G Gigabit Ethernet Switch Management GuidePage 9033640 9033640 Table of Contents Snmp Management Appendix A. Spanning Tree ConceptsAppendix B. Virtual Lans Vlans Vi Table of Contents Required Connections Configuration OptionsManagement Overview Console Port Out-of-Band ConnectionsTelnet Connection In-Band ConnectionsIn-Band Network Connection VH-8G User Interface OverviewUser Access Factory Defaults Factory Default SettingsGvrp Main Menu Selection DescriptionDisplays/configures extended bridge capabilities provided by System Information Menu System Information MenuDisplaying System Information System InformationDisplaying Switch Version Parameter DescriptionManagement Setup Menu Management Setup MenuChanging the Network Configuration Network ConfigurationIP Configuration IP ConfigurationIP Connectivity Test Ping IP Connectivity TestHttp Configuration 10. Http ConfigurationConfiguring the Serial Port 11. Serial Port Configuration12. Snmp Configuration Assigning Snmp ParametersConfiguring Community Names 13. Snmp CommunitiesConfiguring IP Trap Managers 14. IP Trap ManagersConsole Login Configuration 15. Console Login ConfigurationUsing Tftp Protocol to Download Over the Network Downloading System SoftwareSaving the System Configuration 17. Configuration Save & RestoreConfiguring Management Access 18. Management ConfigurationConfiguring the Switch 19. Device Control MenuNot implemented in the current firmware release Configuring Port Parameters 20. Port ConfigurationViewing the Current Port Configuration 21. Port InformationUsing the Spanning Tree Algorithm 22. Spanning Tree Configuration Configuring Bridge STADevice with the lowest MAC address will then Configuring STA for Ports 24. Spanning Tree Port ConfigurationViewing the Current Spanning Tree Configuration 25. Spanning Tree InformationDisplaying the Current Bridge STA 26. Bridge STA InformationDisplaying the Current STA for Ports 27. Spanning Tree Port InformationRules defining port status are Using a Mirror Port for Analysis 28. Mirror Port ConfigurationConfiguring Port Trunks 29. Port Trunking Configuration Igmp Multicast Filtering Configuring Igmp 30. Igmp ConfigurationConfiguring Broadcast Storm Control 31. Broadcast Storm Control ConfigurationConfiguring Bridge MIB Extensions 32. Extended Bridge ConfigurationBy setting this parameter to False Configuring Traffic Classes 33 .1P ConfigurationPort Priority Configuration 34 .1P Port Priority Configuration802.1P Port Traffic Class Information 35 .1P Port Traffic Class InformationConfiguring Virtual LANs 802.1Q Vlan Base Information802.1Q Vlan Current Table Information 37 .1Q Vlan Current Table Information802.1Q Vlan Static Table Configuration 38 .1Q Vlan Static Table Configuration39 .1Q Vlan Static Table Configuration Example Port Assignment Vlan Configuration 40. Port Assignment Vlan ConfigurationMulticast Router Port Information 41. Multicast Router Port InformationStatic Multicast Router Port Configuration 42. Static Multicast Router Port ConfigurationIgmp Member Port Configuration 43. Igmp Member Port ConfigurationPort Security Configuration 44. Port Security ConfigurationMonitoring the Switch 45. Network Monitor MenuDisplaying Port Statistics 46. Port StatisticsDisplaying Rmon Statistics 47. Rmon StatisticsDrop Events Displaying the Unicast Address Table 48. Unicast Address TableDisplaying the IP Multicast Registration Table 49. IP Multicast Registration TableConfiguring Static Unicast Addresses 50. Static Unicast Addreeess Table ConfigurationResetting the System Logging Off the System64 VH-8G User Interface Configuring & Monitoring the Switch Common TasksSetting Password Protection Connecting via Telnet Checking Network Configuration StatusAssigning an IP Address Setting Snmp Management Access Viewing Switch StatisticsConfiguring Port Mirroring Downloading a Software UpgradeDownloading Via the Serial Port SuccessDownloading Via Tftp Configuring Spanning Tree Parameters Configuring VLANs Configuring Class of ServiceConfiguring Port Operation Configuring the Unicast Address Table Setting a Default Gateway Configuring BootPConfiguring Port Trunks VH-8G Snmp Management Snmp ProtocolMIB Objects RFC 1213 MIB-IIRFC 1643 Ethernet-Like MIB RFC 1573 Interfaces Evolution MIBRFC 1493 Bridge MIB Ieee 802.1Q Q-MIB Compiling MIB Extensions Enterasys WebsiteEnterasys Proprietary MIB Extensions Appendix A. Spanning Tree Concepts Spanning Tree FeaturesGeneral Figure A-1. Spanning Tree Using an VH-8G Switch Spanning Tree Protocol in a NetworkTable A-1. Spanning Tree Protocol Defaults Spanning Tree Protocol ParametersSpanning Tree Protocol Operation 9033640 Spanning Tree Concepts VH-8G Appendix B. Virtual Lans Vlans VLANs and Frame TaggingVlan Classification VH-8G Vlan ConfigurationAssigning Ports to VLANs Port OverlappingForwarding Tagged/Untagged Frames Automatic Vlan RegistrationForwarding Traffic with Unknown Vlan Tags Appendix C. Class of Service Incoming tagged frames contain a priority level rangeFigure C-1. Class of Service Example Appendix D. IP Multicast Filtering Igmp Snooping and IP Multicast FilteringVH-8G Index Tftp 9033640 Index Page Page 150183-102 R01