Enterasys Networks 2G4072-52 manual Connecting to a Modem, Connecting a VT Series Terminal

Connecting to the COM Port for Local Management

4.Turn on the terminal and access the Setup Directory. Set the following parameters:

Parameter	Setting
Mode	7 Bit Control
Transmit	Transmit=9600
Bits Parity	8	Bits, No Parity
Stop Bit	1	Stop Bit

When these parameters are set, the Local Management password screen will display. Refer to the Enterasys Matrix N Standalone Series Configuration Guide for further information.

Figure 3-13 Connecting a VT Series Terminal

RESET

à  
	CPU
CONSOLE	PWR

Á

GROUP 3

GROUP SELECT

GROUP 2

GROUP 1

1	UTP cable with RJ45 connectors	3	RJ45-to-DB25 VT adapter
2	RJ45 COM port	4	VT series terminal

Connecting to a Modem

To connect a modem to the device COM port (Figure 3‐14), use a UTP cable with RJ45 connectors and an optional RJ45‐to‐DB25 male adapter, and proceed as follows:

1.Connect the RJ45 connector at one end of the cable to the COM port of the module.

2.Plug the RJ45 connector at the other cable end into the RJ45‐to‐DB25 modem adapter.

3.Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.

N Standalone Series Installation Guide 3-15