On the existing router or gateway, disconnect the Ethernet cable for an existing piece of equipment connected to an ETHERNET (or LAN) port. This equipment will be connected to the Ethernet switch in step 2, below.
Note: Do not disconnect the cable connected to the router or gateway port labeled BROADBAND,
INTERNET, or WAN.
Connect the Ethernet cable disconnected in step 1 to an available ETHERNET port on the Ethernet switch. Refer to the Ethernet switch’s installation instructions for any additional instructions and special considerations. If the Ethernet switch has a power adapter, connect it and plug it in according to the switch’s instructions.
Connect an Ethernet cable to the ETHERNET (or LAN) port on the router or gateway that was made available in step 1.
Connect the other end of the Ethernet cable to an available ETHERNET port on the Ethernet switch.
Verify that the personal computer and any other equipment connected to the Internet connection continues to function properly after it has been connected to the Ethernet switch. Connect the DISH Network satellite receiver using the steps in Connecting the Satellite Receiver to an Available Ethernet Port on page 7.
Page 6