Dish Network HOME NETWORK Setting up the Receiver, Select Done to exit the Network Setup screen

Page 11
Select Done to exit the Network Setup screen.

Setting up the Receiver

Once the receiver has been connected to the home network, use these steps to set up and verify the receiver’s Internet connection.

Using the DISH Network remote control for the receiver that is connected to the home network, access the Network Setup screen by pressing MENU, selecting System Setup, Installation, Broadband Setup, then Network Setup. Verify the IP address is populated (not all 0s). If the IP address is all 0s, select Reset Connection. An Attention 875 message will display briefly, then you will return to the Network Setup screen.

Network Setup Screen

Attention 875 Message

Verify the Connection Status on the Network Setup screen shows Connected Online, and that the IP address does not show all 0s. If the IP address shows all 0s or the Connection Status shows Not Connected, refer to Troubleshooting on page 12.

Network Setup Screen with IP Address

Select Done to exit the Network Setup screen.

Page 10

Image 11
Contents Installation Instructions Home NetworkQuick Installation Instructions Installation InstructionsTable of Contents Installation ConsiderationsOverview Quick Installation InstructionsIdentifying the Home Network and Receiver Connection Method Identifying and Creating the Home Network and Available Ethernet PortFigure 3. Identifying Available Ethernet Port No. Go to Adding an Ethernet Switch on pageFigure 4. Identifying Ethernet Switch or Hub Figure 5. Identifying Available Ethernet Port on Switch or HubDiagram 2. Connecting an Ethernet Switch to the Router Installation and SetupAdding an Ethernet Switch Diagram 1. Overview of Home Network with Ethernet Switch ConnectedINTERNET, or WAN Diagram 4. Connecting the Receiver to the Router Using Ethernet Cable Connecting the Satellite Receiver to an Available Ethernet PortEthernet Port Ethernet Port One HomePlug-to-Ethernet adapter must be obtained for use at the location of the router, gateway, or Ethernet switch. One adapter supports up to 15 receivers. The ViP-series of DISH Network receivers include HomePlug 1.0 support. HomePlug Turbo adapters can also be used Select Done to exit the Network Setup screen Diagnostics Screen Using DishONLINE After Hours Description TroubleshootingProcedure HomePlug Troubleshooting section on pageNetwork Setup. Select Reset Connection address on the receiver’s Network Setup screen shows all 0s on pageHomePlug 156342