Programming the device code using auto setup mode
If your device does not respond to the remote control after trying all codes listed for your brand, try searching for your code using these steps for auto setup mode.
1Turn on the TV. Turn on the device you would like to program.
2Press Device button on the remote control as needed to select AUD, STB, or DVD that you want to program.
3Hold down Device button on the remote control for 5 seconds until the device light blinks, and then release the device button. The device light blinks one more time and then remains lit indicating the remote control is in programming mode.
4Enter 1, 1, 1, 1, and the device light blinks once and then remains lit.
5Aim the remote control at the device. Press and release the Power button once on the remote control. Wait until the device light stops blinking.
■If the device turns off, continue with step 6.
■If the device does not turn off, continue to press and release the Power button, waiting each time for the device light to stop blinking, until the home entertainment device turns off.
n
Each time you press the Power button, the auto setup is trying a different code. Be sure to wait until the device light stops blinking before pressing the Power button again. You may need to press the Power button several times before the correct code is found.
6Once the home entertainment device turns off, press the OK button on the remote control to save the code.
Using the Remote Control
Using the Remote Control 43