MN05401014E:MN05401014E 2/9/07 1:26 PM Page 2
c1. Hold the left key pressed and press the right key to leave the programming operation
c2. Press the right key to switch to
.
d.Hold the left key pressed and press the right key to switch to the first parameter.
e.After releasing the keys, the display alter- nates between the menu title and the current menu item setting. After pressing any key, only the menu item setting is displayed.
f.Pressing the right key will switch the menu item setting to the next value.
If figures are to be input (e.g. when setting the scaling factor), select first the digit using the left key, and then set the value using the right key.
g.Hold the left key pressed and press the right key to switch to the next menu item.
h.The last menu title “EndPro” allows the user, when selecting “Yes”, to exit the programming menu and to store the new values. If “no” is selected, the programming routine is repeat- ed, the latest values set remaining active. They can now be checked again or modified.
4. Programming routine
The programmable parameters of the device are described below, in succession. The device is fully programmed after one pass of the routine.
The first values stated correspond to the factory settings.
4.1 Polarity of the inputs
npn: sinking sensor
pnp: sourcing sensor
4.2 Switching on the 30 Hz filter (INP)
The filter provides input damping*
30 Hz filter off (fmax)
30 Hz filter on
4.3 Decimal point setting
The decimal point determines the way of displaying the count values. It does not affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
4.4 RESET Mode
manual reset via the red RESET key and electrical reset via the RESET input
no reset (red RESET key and RESET input locked)
only electrical reset via the RESET input
only manual reset via the red RESET key
4.5 End of programming
The programming routine is repeated once more. The values set until now can be checked and modified.
The programming routine will be exited and all values set will be stored as new parameters.
Afterwards the device is ready for operation.
* where bounce occurs, e.g. with contacts
2 | MN05401014E |