Hop Count | The number of hops (routers) to pass through to |
| reach the destination LAN. |
Interface | The interface that go to the next hop (router). |
Add a Rule | Fill in the "Destination LAN IP", "Subnet Mask”, |
| “Default Gateway”, "Hop Count" and "Interface" of |
| the rule to be added and then click "Add". Then |
| this rule of Static Routing will be added into the |
| "Static Routing Table" below. If you find any typo |
| before adding it and want to retype again, just |
| click "Reset" and the fields will be cleared. |
Remove a Rule | If you want to remove some routing rules from the |
| "Static Routing Table", select the rules you want |
| to remove in the table and then click "Delete |
| Selected". If you want remove all rules from the |
| table, just click "Delete All" button. Click "Reset" |
| will clear your current selections. |
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance sections or start using the router (with the advance settings in place)
2.7 Firewall
The Broadband router provides extensive firewall protection by restricting connection parameters, thus limiting the risk of hacker attack, and defending against a wide array of common Internet attacks. However, for applications that require unrestricted access to the Internet, you can configure a specific client/server as a Demilitarized Zone (DMZ).
Note: To enable the Firewall settings select Enable and click Apply
64