Edimax Technology Wireless VPN Broadband Router user manual Wan

Page 32

Host Address This is the IP address of the host in the Internet that will have management/configuration access to the Broadband router from a remote site. This means if you are at home and your home IP address has been designated the Remote Management host IP address for this router (located in your company office), then you are able to configure this router from your home. If the Host Address is left 0.0.0.0 this means anyone can access the router’s web- based configuration from a remote location, providing they know the password.

Click the Enabled box to enable the Remote Management function.

Note: When you want to access the web-based management from a remote site, you must enter the router’s WAN IP address (e.g. 10.0.0.1) into your web- browser followed by port number 8080, e.g. 10.0.0.1:8080 (see below). You’ll also need to know the password set in the Password Setting screen in order to access the router’s web-based management.

Port

The port number of remote management web interface.

Enabled

Select “Enabled” to enable the remote management

 

function.

 

 

Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance sections or start using the router (with the advance settings in place)

2.2 WAN

Use the WAN Settings screen if you have already configured the Quick Setup Wizard section and you would like to change your Internet connection type. The WAN Settings screen allows to specify the type of WAN port connect you want to establish with your ISP. The WAN settings offer the following selections for the router’s WAN port, Wireless-WISP, Dynamic IP, Static IP Address, PPPoE, PPTP, L2TP, Telstra Big Pond, DNS and DDNS.

31

Page 31 Page 33
Image 32
Page 31 Page 33
Contents User’s Manual Page NAT Minimum Requirements FeaturesPackage Content Reset Get to know the Broadband Router Back PanelLocal Area Network LAN Wide Area Network WANFront Panel Light Status DescriptionGetting started Setup DiagramConfigure your PC to obtain an IP address automatically DNS Configuration Select Disable DNS 2b Windows XP 2c Windows 2d Windows NT IP Address Select Obtain an IP address from a Dhcp serverPage Quick Setup Wizard Chapter General Setup ChapterQuick Setup Status Info. ChapterSystem Tools Chapter Time ZoneBroadband Type Pptp L2TPCable Modem Fixed-IP xDSL DNSPPPoE MTU Pptp BEZEQ-ISRAEL L2TP Type in this MAC address in this section or use Turn OFF the Router When YOU Finished Using the Internet Telstra Big PondGeneral Settings WAN LANNAT SystemTime Zone Password Settings Remote Management WAN Page Wireless ISP Dynamic IPStatic IP Address PPPoE PPP over EthernetPage Ddns LAN LAN IPWireless Basic Settings SettingEssid Wlan MACAdvanced Settings Page Iapp SecurityWEP only 3.2 802.1x only 3.3 802.1x WEP Static key WPA Pre-shared keyWpatkip WPA2AESWPA Radius Access Control QoS Page Edit QoS Rule Will apply to. You can assign a single port number NAT Port Forwarding Page Virtual Server Page Example Virtual Server Special ApplicationsPage Example Special Applications ExampleUPnP Settings ALG Settings Static Routing Firewall Access Control Rule for users by IP addresses Add PC Client PC Service Example Access ControlURL Blocking DoS Denial of Service Intrusion Detection Feature4 DMZ VPN Status Status and Information Internet Connection Primary DNS and Secondary DNS being usedDevice Status System Log Security Log Active Dhcp Client Statistics Tool Configuration Tools Restore to Factory Defaults tool to forceFirmware Upgrade Perform a reset. Your settings will not be Appendix a How to Manually find your PC’s IP and MAC address Glossary Page TCP FTP Smtp POP3 TCPSnmp UCP UDP
Top Page Image Contents