Edimax Technology PS-1206MFG manual Setup Wizard, System, Admin Password

Page 45

6.4Setup Wizard

Note: You can configure the MFP Server from the Setup Wizard. To let the changes take effect, you have to click “Save Settings” in the menu on the left side to reboot the MFP Server.

6.4.1System

6.4.1.1Admin Password

You can change the MFP Server name and port name from here.

MFP Server Name: the name of the MFP Server. You can use this name to identify the MFP server when you are searching for if using by the “Server Manager” utilities.

PORT Name: The name of the port which MFP server plugs on. The default port name is ‘’p1’’.

34

Image 45
Contents Page Page FCC Warning Federal Communication Commission Interference StatementRadio Frequency Interference Requirements RSS-210 Compliance Statement Country Code Setting DisableTransmitter Antenna IC Radiation Exposure StatementTTE Compliance Statement SafetyEU Countries Intended for Use CE Mark WarningRegulatory Approvals for AC Adapter Epson Safety InformationPage Contents Troubleshooting Introduction MFP Server Modes All-in-one MFP Server ModeMFP Server Mode Using Your All-in-one in MAC Page Printing Scanning MAC Scanning Utility Reading Memory Cards MFP Server List MFP Manager in MACMFP Server List MFP Server List General Setting Option SettingsSearch for MFP Server Introduction Server Configuration in MACSearch for All Available MFP Server Status of MFP Server Page General Setting Page TCP/IP Configuration IP Address AssignmentIP Address Subnet Mask System Configuration Wireless Configuration Page WEP Security Mode Page WPA-PSK/WPA2-PSK Security Mode Page Web Management IP Address User Name Admin PasswordLogin System Status Device StatusPrinter Status 3 TCP/IP Status Setup Wizard Admin PasswordSystem Page Advanced Settings Wireless Page Site Survey Encryption Page WPA-PSK Mode WPA2-PSK Mode Security Mode 3 TCP/IP Save Settings System Tools Load DefaultUpgrade Firmware Troubleshooting