Edimax Technology PS-1206MFG manual Wireless

Page 48

6.4.2Wireless

If you want to use the MFP Server through a wireless LAN, please set up the MFP Server through Ethernet first and make sure your wireless LAN setting is correct. After setting the wireless LAN, unplug the Ethernet cable and restart the MFP Server. Then you can start to use the MFP Server through the wireless LAN. If the wireless configuration does not work, please plug in the Ethernet cable again, restart the MFP Server and configure the MFP Server through Ethernet until the wireless LAN settings are correct.

You can enable/disable the wireless function and set up the wireless parameters for the MFP Server from here. The parameters include “Function” and “ESSID”. You can manually set the wireless network that you want to connect in this page or use the “Site Survey” function to automatically search for an available wireless network and associate with it.

Function allows you to disable, enable or let the MFP Server auto select to connect to a wired or wireless network. If “Disable” is selected, the MFP Server can only connect to the network through wired Ethernet. If “Enable” is selected, the MFP Server can only connect to the network through a Wireless LAN. If “Auto” is selected, the MFP Server can automatically decide to enable or disable the wireless function. The MFP Server only can work in either Ethernet or wireless LAN mode. It cannot work in both Ethernet and wireless LAN mode at the same time. When the MFP Server starts up, it will auto-detect if the LAN port is connected to an active network by an Ethernet cable. If the MFP Server is connected to an active network by Ethernet cable when starting up, the MFP Server will run in Ethernet mode. If the MFP Server is not connected to an active network by Ethernet cable when starting up, the MFP Server will run in

37

Image 48
Contents Page Page Federal Communication Commission Interference Statement FCC WarningRadio Frequency Interference Requirements Country Code Setting Disable RSS-210 Compliance StatementTransmitter Antenna IC Radiation Exposure StatementSafety TTE Compliance StatementEU Countries Intended for Use CE Mark WarningRegulatory Approvals for AC Adapter Safety Information EpsonPage Contents Troubleshooting Introduction All-in-one MFP Server Mode MFP Server ModesMFP Server Mode Using Your All-in-one in MAC Page Printing Scanning MAC Scanning Utility Reading Memory Cards MFP Manager in MAC MFP Server ListMFP Server List MFP Server List Option Settings General SettingSearch for MFP Server Server Configuration in MAC IntroductionSearch for All Available MFP Server Status of MFP Server Page General Setting Page TCP/IP Configuration IP Address AssignmentIP Address Subnet Mask System Configuration Wireless Configuration Page WEP Security Mode Page WPA-PSK/WPA2-PSK Security Mode Page IP Address User Name Admin Password Web ManagementLogin Device Status System StatusPrinter Status 3 TCP/IP Status Setup Wizard Admin PasswordSystem Page Advanced Settings Wireless Page Site Survey Encryption Page WPA-PSK Mode WPA2-PSK Mode Security Mode 3 TCP/IP Save Settings Load Default System ToolsUpgrade Firmware Troubleshooting