Edimax Technology PS-1206MFG manual 3 TCP/IP

Page 55

6.4.3TCP/IP

You can configure the MFP Server to automatically get an IP address from DHCP server or manually specify a static IP.

If you need the MFP Server to automatically get an IP address from a DHCP server, select “Enable Obtain TCP/IP Settings Automatically (Use DHCP/ BOOTP)”. You also can select “Disable Use the following TCP/IP Settings” to manually assign an “IP Address”, “Subnet Mask” and “Gateway” for the MFP Server.

44

Image 55
Contents Page Page FCC Warning Federal Communication Commission Interference StatementRadio Frequency Interference Requirements IC Radiation Exposure Statement Country Code Setting DisableRSS-210 Compliance Statement Transmitter AntennaCE Mark Warning SafetyTTE Compliance Statement EU Countries Intended for UseRegulatory Approvals for AC Adapter Epson Safety InformationPage Contents Troubleshooting Introduction MFP Server Modes All-in-one MFP Server ModeMFP Server Mode Using Your All-in-one in MAC Page Printing Scanning MAC Scanning Utility Reading Memory Cards MFP Server List MFP Manager in MACMFP Server List MFP Server List General Setting Option SettingsSearch for MFP Server Introduction Server Configuration in MACSearch for All Available MFP Server Status of MFP Server Page General Setting Page IP Address Assignment TCP/IP ConfigurationIP Address Subnet Mask System Configuration Wireless Configuration Page WEP Security Mode Page WPA-PSK/WPA2-PSK Security Mode Page Web Management IP Address User Name Admin PasswordLogin System Status Device StatusPrinter Status 3 TCP/IP Status Admin Password Setup WizardSystem Page Advanced Settings Wireless Page Site Survey Encryption Page WPA-PSK Mode WPA2-PSK Mode Security Mode 3 TCP/IP Save Settings System Tools Load DefaultUpgrade Firmware Troubleshooting