Dell specifications PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

¾Trap Configuration

In previous versions of the software, configuration of the flags for controlling traps was scattered about in a number of places.

snmp-server enable traps is now a common command for configuring all trap flags. The legacy commands are preserved for backward compatibility. Also note that the keyword “trap” has changed to the plural “traps”.

¾SNTP Server Priority

The server priority is now available from the show sntp configuration command. Previously it was only configurable.

¾GARP Leave Timer

The valid range for the GARP leave timer has been changed to 20-600 centiseconds.

¾IP Multicast Static Route Configuration

The command for configuring a static IPv4 multicast route has changed to ip mroute. The ip multicast staticroute command is deprecated.

¾Support for Long User Names

The show users, show users accounts, and show users login-history commands have changed. The long parameter has been added to these commands to support long usernames.

¾Flow Control

Flow Control is enabled by default.

Note: When you upgrade a switch to this release, flow control is automatically enabled. If your previous configuration had flow control disabled, you must disable flow control after the upgrade to match the previous configuration.

¾VLAN Limit Increases

MAC based VLAN limit was increased from 128 to 256. Subnet based VLAN limit was increased from 64 to 128.

System Firmware Version 3.2.0.6 Page 13