Dell specifications PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

Page 29

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

Summary

User Impact

Workaround

ISDP updates are not

Upon changing configuration immediately

The administrator can work around this

including Voice VLAN

after getting the VLAN assigned, DUT stops

problem by shutting down the port and

Reply TLV when

advertising Voice VLAN reply TLV in its

restarting it after the configuration is

Voice VLAN ID on

ISDP updates which causes IP phone to

changed.

interface is changed.

change its VLAN properties.

 

PC6200 fails to re-

Once a phone is configured, enable Voice

Disconnect and reconnect the phone to the

authorize IP phone

VLAN authentication, wait for DHCP

port, the phone gets authorized.

upon enabling and

discovery again, and then disable Voice

 

disabling Voice VLAN

VLAN authorization. On disabling Voice

 

authentication.

VLAN authorization, PC6200 fails to

 

 

authorize IP phone based on the received

 

 

LLDP packet (with network policy TLV).

 

When Line or enable

If login authentication method is Line or

If enable authorization is set to None, ensure

method is used as

Enable, and enable authentication is None,

that the login authorization method is at least

login method and

you will always get read-only access

TACACS, Radius, or Local. Any

enable authentication

(because there is no user configured for line

authentication method that requires a user

is none, the user is

or enable authentication). The user will

configuration will ensure that the user will get

unable to enter into

never get read-write access.

proper access based on how the user is

Privileged EXEC

 

configured.

mode.

 

 

Cannot change LAG

Cannot change LAG mode from Static to

The user may change the LACP Mode using

mode from Static to

Dynamic via CLI.

the Graphical User Interface.

Dynamic via CLI.

 

 

System Firmware Version 3.2.0.6

Page 27

Image 29
Contents PowerConnect 6224/6224F/6224P/6248/6248P Release Notes Table of Contents Global Support Firmware Specifications Firmware Version DetailsFirmware Upgrade Supported Firmware Functionality Hardware SupportedFirmware Downgrade Version No Release DateAdded Functionality in this Release System Firmware Version PowerConnect 6224/6224F/6224P/6248/6248P Release Notes System Firmware Version PowerConnect 6224/6224F/6224P/6248/6248P Release Notes ¾ auto-cost reference bandwidth and bandwidth Commands PowerConnect 6224/6224F/6224P/6248/6248P Release Notes System Firmware Version Changed Functionality in this Release ¾ bridge address Command Changed PowerConnect 6224/6224F/6224P/6248/6248P Release Notes Maximum rules per ACL are Deprecated Commands and Parameters Ip ospf areaid Title Description Ip ospfDescription User Impact Resolution Issues ResolvedNo switch 2 priority 2 command Snmp-server host ipaddress and soWeb page EAP Statistics Before processing System Firmware Version Title Description Non-Stop ForwardingNsf ietf helper strict-lsa-checking No nsf ietf helper strict-lsa-checkingVlan Name Support with Radius Server Port Configuration Show CommandCustom Protocol Based VLANs Configurable Message of the Day Banner Stacking/CX-4 Module ConfigurationRadius Accounting Servers Spanning TreeLink Dependency Commands User’s Guide UpdatesConfiguring Dell PowerConnect Title Description MulticastSummary User Impact Workaround Known IssuesShow running PowerConnect 6224/6224F/6224P/6248/6248P Release Notes 802.1AB Lldp Known Restrictions and Limitations LayerQoS 802.1XDescription User Impact Ip default gateway and ip default Description User Impact Vlan association mac commandInterfaces. ip default gateway is for IP MapMulticast IcmpWeb-based Management ManagementFile Management Cable Diagnostics