Dell 6224F Issues Resolved, Description User Impact Resolution, Snmp-server host ipaddress and so

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

Issues Resolved

The following is a list of issues resolved in the current firmware release.

Description	User Impact		Resolution
Unable to configure IPv6 host	User is not aware that the only IPv4		Updated the help string to mention
(4001::2) as an SNMP trap	address is accepted by the command		that IPv4 address is expected as input
receiver on the DUT.	snmp-server host <ipaddress> and so		for snmp-server host <ipaddress>
	may try to give IPV6 address as input.		CLI command.
WFB: Logging messages show	Logging messages show UTC time		Used simAdjustedTimeGet()
UTC time only.	instead of updated time with timezone		function for correcting log messages
	offset.		time.
Web: Zone config incorrect	Zone is not correctly populated on the		Added an object to get the
with summer time config.	web page with the summertime taken into		information on summertime check
	consideration.		and based on this value, populating
			the zone in the web page.
MLD Packets are not snooped,	PC6200 cannot properly identify IPv6		Added a new MLD rule to the FFP
when sending MLD packets	MLD packets that have the hop-by-hop		which will trap to the CPU IPv6
with Hop-by-Hop header with	option set like other chips such as FP2.		Membership reports which use the
Router Alert Option.			well known MAC address
		33:33:00:00:00:16.
Firmware missing no	The no switch 2 priority 2 command		Added the no version of the
command to remove switch x	does not work. There is no no form for		command, setting the value to the
priority x.			default.
Missing RFC1213 MIB-2	User could not walk all objects in SNMP		Re-enabled objects to provide
SNMP Trap counter.	group.		support even though the objects
			were obsoleted in RFC
Member xx changes do not	If there is an unsaved member, standby,		Set the unitMgrCfgFile ->
result in prompt to save	or NSF configuration, user is not warned		dataChanged flag in the respective
running-config on reload.	of the unsaved configuration on issuing		APIs.
	reload.
Cut-through mode does not	The user cannot determine how cut-		Added a comment to the running
show in running-config.	through mode is configured via the show		config to indicate when the switch is
	running-config command.		configured in cut-through mode. The
			switch must be rebooted for the cut-
			through configuration to be
			changed.
Asset-tag is not set on stack	If a user would run the show system id		Process SET_ASSET_TAG event
members.	on the stack member, the asset tag would		while in
	not be displayed.		connected_unit/connected_stby
			state.
GVRP CLI vs. GUI	CLI and Web field names are different		Make the Web field names similar to
inconsistency.	and used reverse to each other.		those of CLI such that the
			configuration is understood
			correctly.
Configured non-existing host	Configured non-existing host cannot be		Corrected logic so that only valid
cannot be deleted for logging	deleted for logging syslog.		servers could be deleted.
syslog.
Syslog server CLI description	Validation for syslog description is		Added validation for syslog
accepts invalid control	different between Web and CLI.		description in CLI to accept control
characters			characters: 'a-z' 'A-Z' '0-9' " " ' @
		' ' # ' ' $ ' ' _ ' ' - ' ' . '

System Firmware Version 3.2.0.6 Page 17