Dell 6248P Radius Accounting Servers, Spanning Tree, Stacking/CX-4 Module Configuration, Dot1X

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes

RADIUS Accounting Servers

Title	Description
radius-server host acct	The switches do not support creating accounting server names with the
	same name although the CLI Reference Manual and User Guide state
	that it is supported.
	Default: Not applicable

Spanning Tree

Title	Description
no spanning-tree transmit hold-count	The hold-count keyword is not required when resetting the spanning-tree
	transmit hold-count.
	Default: Not applicable

Stacking/CX-4 Module Configuration

Title	Description
stack-port<unit>/<port-type> <port-num>	This command is used to configure a port on a CX-4 or stacking plug-in
{ethernet stack}	modules as either an ethernet or stack port.
	Default: From the factory the ports are all configured as Ethernet ports.
	If upgrading from a previous release the modes will be preserved and no
	configuration should be necessary.

Configurable Message of the Day Banner

Title	Description
banner motd <message>	Controls (enables or disables) the display of message-of-the-day banners.
	‘banner motd’ enables the banner, and allows configuration of message-
no banner motd	of-the-day banners. Use ‘no banner motd’ to delete the message, and
	disable the banner.
	Default: Disabled by default.
banner motd acknowledge	The user will be required to acknowledge the banner displayed on the
	console if ‘banner motd acknowledge’ is executed. The user would have
no banner motd acknowledge	to type "y" or "n" to continue to the login prompt. If "n" is typed, the
	session is terminated and no further communication is allowed on that
	session. However, serial connection will not get terminated if user does
	not enter ‘y’. Use ‘no’ form of the command to disable banner
	acknowledge.
	Default: Disabled by default.

Dot1X

Title	Description
dot1x timeout guest-vlan-period	Use this command in Interface Config Mode to set the number of seconds
	that the switch waits before authorizing the client if the client is a dot1x
	unaware client.
	Default: The switch remains in the quiet state for 90 seconds.
	Refer to the Dell™ PowerConnect™ 6200 Series Systems CLI Reference
	Guide for details.

System Firmware Version 3.2.0.6 Page 23