1. OPERATION
CALIBRATION ?
ARE YOU SURE ?
YES
NO
Calibration prompt
6.Choose YES and then press the [ENT] key. The display shows “CALIBRATION??” during calibration. (To cancel calibration, press the [MENU] key. You cannot cancel calibration except when SAMPLING is showing “??”.)
7.Continue turning the boat in a circle until calibration results, NG (No Good) or OK, appear on the display. This takes about
CALIBRATION
SAMPLING : OK
CALIBRATION : OK
RESULT: OK
Calibration results
8.The display then shows “PUSH ENT KEY.” Push the [ENT] key to return to the HDG SETUP menu.
Note: If the results were unsuccessful, NG appears as the results. In this case, press the [MENU] key or the [ENT] key to return to the HDG SETUP menu. Redo the calibration referring to the installation manual for the heading sensor.
9.If you do not need to align heading or enter a damping factor